Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 201-051-3
CAS number: 77-71-4
The pile failed to ignite during the
two minutes that the Bunsen flame was applied.
The result of the preliminary
screening test obviated the need to perform the main test.
a) Mass of loss bottle (g)
b) Mass of loss bottle and test material (g)
c) Mass of loss bottle and test material after drying (g)
Moisture content (% w/w)
Mean moisture content (% w/w)
flammability (solids) was determined by measuring the burning rate of
test material prepared as a pile of set dimensions. Testing was
conducted using Method A10 Flammability (Solids) ofCommissionRegulation
(EC) No 440/2008 of 30 May 2008.
mould (250 x 20 x 10 mm) was loosely filled with test material (tested
as received). A non-combustible, non-porous board was placed onto
the mould which was then inverted. The mould was removed and an
air-rich Bunsen burner flame applied to one end of the pile for two
moisture content was determined gravimetrically.
pile failed to ignite during the two minutes that the Bunsen flame was
test material has been determined to be not highly flammable as it
failed to ignite in the preliminary screening test.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Do not show this message again