Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 202-936-7
CAS number: 101-37-1
Description of first aid measures
Pay attention to self-protection.
Remove victims from hazardous area. Immediately remove soiled or soaked clothing and remove it to a safe distance. Keep victim warm, in a stabilized position and covered.
Do not leave victims unattended.
If the casualty is unconscious: Place the victim in the recovery position.
Potential for exposure by inhalation if aerosols or mists are generated.
Move victims into fresh air.
With labored breathing: Provide with oxygen. Consult a doctor.
If the casualty is not breathing: Perform mouth-to-mouth resuscitation, notify emergency physician immediately.
Wash off affected area immediately with plenty of water.
Continue decontamination with polyethylene glycol 400 after initial rinsing with water and then wash with water and soap.
If symptoms persist, consult a physician for treatment.
With eye held open, thoroughly rinse immediately with plenty of water for at least 10 minutes.
Consult an ophthalmologist immediately if the symptoms persist.
Rinse out mouth.
Immediately give large quantities of water to drink.
Consult a physician immediately.
Indication of any immediate medical attention and special treatment needed
After accidental absorption in the body, the pathology and clinical findings are dependent on the kinetics of the noxious substance (quantity of absorbed substance, the absorption time, and the effectiveness of early elimination measures (first aid)/ excretion - metabolism).
Continue with first aid measures.
Depending on the pathology and clinical findings, patient monitoring and symptomatic treatment are necessary.
Suitable extinguishing media
Water, water vapour, extinguishing powder, extinguishing foam
Unsuitable extinguishing media
Do not use a solid water stream as it may scatter and spread fire.
Special hazards arising from the substance or mixture
Danger of decomposition under influence of heat.
Risk determining decomposition products:
In the case of fire, the following hazardous smoke fumes may be produced:
Special protective equipment for fire-fighters
In the event of fire, wear self-contained breathing apparatus.
full protective suit
Advice for firefighters
In case of fire, remove the endangered containers and bring to a safe place, if this can be done safely.
In case of fire cool containers or take them to a safe place.
Use water spray to cool unopened containers.
Contaminated extinguishing water must be treated at a suitable disposal plant in accordance with waste management laws.
Ensure there are sufficient retaining facilities for water used to extinguish fire.
Fire residues should be disposed of in accordance with the regulations.
Keep out unprotected persons.
Personal precautions, protective equipment and emergency procedures
Wear personal protective equipment.
Keep unauthorized persons away.
Prevent substance from entering soil, natural bodies of water and sewer systems.
If the product contaminates rivers and lakes or drains inform respective authorities.
Methods and material for containment and cleaning up
Absorb with liquid-binding material, e. g.: diatomaceous earth, sand, universal binder
Dispose of absorbed material in accordance with the regulations.
Waste to be packed like clean product and to be marked. Identification label on packages not to be removed until recycling.
Precautions for safe handling
Keep in a dry, cool place.
Avoid residues of the product on the containers.
If stored longer an increase in oligomeric material could be expected.
If the material has to be melted we recommend a water bath with a maximum temperature of 50 °C.
An electrical heating of drums or containers is of high risk to initiate polymerization accompanied by strong exotherms.
It should only be used after the careful installation of safety measures, to avoid localized overheating.
For further information we strongly recommend to get in contact withour Applied Technology Department.
As a consequence of the production process, Triallycyanurate can contain traces of ally alcohol; for this reason, an efficient ventilation of the working room(s) should be installed.
Also keep emptied containers away from sources of heat and ignition.
Take precautionary measures against static discharges.
Advice on protection against fire and explosion
Formation of flammable or explosive vapour/air mixtures possible.
Caution - electrostatic charge may occur.
Keep away from sources of ignition - No smoking.
Conditions for safe storage, including any incompatibilities
Approved and licensed tank for liquids with safety adaptations.
Information on request.
Storage temperature: 32 - 38°C
In order to ensure due transportation, make certain that stacks are of the correct height, containers are securely fastened so as not to fall off, and labelled according to the regulations.
Advice on common storage
Observe prohibition against storing together!
German storage class
10 - Combustible liquids neither in Storage Class 3
Ensure suitable suction/aeration at the work place and with operational machinery.
Provide for installation of emergency shower and eye bath.
Personal protective equipment
Use suitable respiratory protection where aerosols/vapours are generated.
When handling for a short time:
Respirator with brown A-type filter
in the event of prolonged exposure during handling:
Respirator with ABEK combination filter
Note time limit for wearing respiratory protective equipment.
Applies to handling for brief periods or of small amounts
Glove material Nitrile, for example, Dermatril P 743, Kächele-Cama Latex GmbH (KCL), Germany
Material thickness 0,20 mm
Break through time 480 min
Method DIN EN 374
Applies to handling for longer periods or of large amounts
Glove material Chloroprene, for example: Camapren 720, Kächele-Cama Latex GmbH (KCL), Germany
Material thickness 0,65 mm
safety glasses with side-shields conforming to EN166
When handling larger quantities: basket-shaped glasses
Skin and body protection
Usual lab protective clothing
When handling larger quantities: chemical protective suit, disposable protective suit
Remove and wash contaminated clothing before re-use.
No eating, drinking, smoking, or snuffing tobacco at work. Wash face and/or hands before break and end of work.
Avoid contact with skin, eyes and clothing.
Use suitable skin protective agents before handling product. Cleanse and apply cream to skin after work. Preventive skin protection recommended.
Handle in accordance with good industrial hygiene and safety practices.
The personal protective equipment used must meet the requirements of directive 89/686/EEC and amendments (CE certification).
It should be defined in the work place in the form of a risk analysis according to directive 89/686/EEC and amendments.
If there is the possibility of skin/eye contact, the indicated hand/eye/body protection should be used
Conditions to avoid
Avoid temperatures in excess of 40°C for longer periods.
Hazardous decomposition products
Possibility of hazardous reactions
Risk of a polymerisation triggered by exothermic reaction above 60 °C
Must be subjected to special treatment in accordance with the regulations issued by the appropriate local authorities e. g. incineration plant
Do not reuse empty containers and dispose of in accordance with the regulations issued by the appropriate local authorities.
Waste Key Number
No waste key number as per the European Waste Types List can be assigned to this product, since such classification is based on the (as yet undetermined) use to which the product is put by the consumer.
The waste key number must be determined as per the European Waste Types List (decision on EU Waste Types List 2000/532/EC) in cooperation with the disposal firm / producing firm / official authority.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
Esta web utiliza cookies para mejorar su experiencia de navegación en nuestros sitios web.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Do not show this message again