Registration Dossier

Administrative data

First-aid measures

General advice:
In the case of accident or if you feel unwell, seek medical advice immediately. When symptoms persist or in all cases of doubt seek medical advice.

Protection of first-aiders:
First Aid responders should pay attention to self-protection, and use the recommended personal protective equipment when the potential for exposure exists.

If inhaled:
If inhaled, remove to fresh air. Get medical attention if symptoms occur.

In case of skin contact:
Wash with water and soap as a precaution. Get medical attention if symptoms occur.

In case of eye contact:
Flush eyes with water as a precaution. Get medical attention if irritation develops and persists.

If swallowed:
If swallowed, DO NOT induce vomiting. Get medical attention if symptoms occur. Rinse mouth thoroughly with water.

Most important symptoms and effects, both acute and delayed
None known.

Indication of any immediate medical attention and special treatment needed
Treatment: Treat symptomatically and supportively.

Fire-fighting measures

Extinguishing media
Suitable extinguishing media: Water spray, Alcohol-resistant foam, Carbon dioxide (CO2), Dry chemical

Unsuitable extinguishing media: High volume water jet

Special hazards arising from the substance or mixture
Specific hazards during fire-fighting: Do not use a solid water stream as it may scatter and spread fire. Flash back possible over considerable distance. Vapours may form explosive mixtures with air. Exposure to combustion products may be a hazard to health.

Hazardous combustion products: Carbon oxides

Advice for firefighters
Special protective equipment for firefighters: In the event of fire, wear self-contained breathing apparatus. Use personal protective equipment.

Specific extinguishing methods: Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Use water spray to cool unopened containers. Remove undamaged containers from fire area if it is safe to do so. Evacuate area.

Accidental release measures

Personal precautions, protective equipment and emergency procedures
Personal precautions: Remove all sources of ignition. Use personal protective equipment. Follow safe handling advice and personal protective equipment recommendations.

Environmental precautions
Environmental precautions: Discharge into the environment must be avoided. Prevent further leakage or spillage if safe to do so. Prevent spreading over a wide area (e.g. by containment or oil barriers). Retain and dispose of contaminated wash water. Local authorities should be advised if significant spillages cannot be contained.

Methods and material for containment and cleaning up
Methods for cleaning up: Non-sparking tools should be used. Soak up with inert absorbent material. Suppress (knock down) gases/vapours/mists with a water spray jet. For large spills, provide dyking or other appropriate containment to keep material from spreading. If dyked material can be pumped, store recovered material in appropriate container. Clean up remaining materials from spill with suitable absorbent. Local or national regulations may apply to releases and disposal of this material, as well as those materials and items employed in the cleanup of releases. You will need to determine which regulations are applicable. Section "disposal considerations" provides information regarding certain local or national requirements.

Handling and storage

Precautions for safe handling
Technical measures: See engineering measures under section "exposure control/personal protection".

Local/Total ventilation: Use with local exhaust ventilation. Use only in an area equipped with explosion proof exhaust ventilation.

Advice on safe handling: Avoid inhalation of vapour or mist. Do not swallow. Avoid contact with eyes. Avoid prolonged or repeated contact with skin. Handle in accordance with good industrial hygiene and safety practice. Keep container tightly closed. Keep away from heat and sources of ignition. Take precautionary measures against static discharges. Take care to prevent spills, waste and minimize release to the environment.

Hygiene measures: Ensure that eye flushing systems and safety showers are located close to the working place. When using do not eat, drink or smoke. Wash contaminated clothing before re-use.

Conditions for safe storage, including any incompatibilities
Requirements for storage areas and containers: Keep in properly labelled containers. Keep tightly closed. Keep in a cool, well-ventilated place. Store in accordance with the particular national regulations. Keep away from heat and sources of ignition.

Advice on common storage: Do not store with the following product types: Strong oxidizing agents, Explosives, Gases.

Specific end use(s): No data available

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Engineering measures
Ensure adequate ventilation, especially in confined areas. Minimize workplace exposure concentrations. Use only in an area equipped with explosion proof exhaust ventilation.

Personal protective equipment
Eye protection: Wear the following personal protective equipment: Safety glasses

Hand protection
Material: butyl-rubber
Glove thickness: 16.6 mm, PVA, 2.7 mm

Remarks: Choose gloves to protect hands against chemicals depending on the concentration and quantity of the hazardous substance and specific to place of work. For special applications, we recommend clarifying the resistance to chemicals of the aforementioned protective gloves with the glove manufacturer. Wash hands before breaks and at the end of workday.

Skin and body protection: Select appropriate protective clothing based on chemical resistance data and an assessment of the local exposure potential.
Wear the following personal protective equipment: Flame retardant antistatic protective clothing.
Skin contact must be avoided by using impervious protective clothing (gloves, aprons, boots, etc).

Respiratory protection: No personal respiratory protective equipment normally required.

Stability and reactivity

Reactivity
Not classified as a reactivity hazard.

Chemical stability
Stable under normal conditions.

Possibility of hazardous reactions
Hazardous reactions: Combustible liquid. Vapours may form explosive mixture with air. Can react with strong oxidizing agents.

Conditions to avoid
Conditions to avoid: Heat, flames and sparks.

Incompatible materials
Materials to avoid: Oxidizing agents

Hazardous decomposition products
No hazardous decomposition products are known.

Disposal considerations

Waste treatment methods
Product: Dispose of in accordance with local regulations. According to the European Waste Catalogue, Waste Codes are not product specific, but application specific. Waste codes should be assigned by the user, preferably in discussion with the waste disposal authorities.

Contaminated packaging: Empty containers should be taken to an approved waste handling site for recycling or disposal. Do not burn, or use a cutting torch on, the empty drum. If not otherwise specified: Dispose of as unused product.