Registration Dossier

Guidance on Safe Use

Guidance on Safe Use

Currently viewing:

Administrative data

First-aid measures

General advice No hazards which require special first aid measures.
Skin contact Wash off with soap and water.
Eye contact Rinse with plenty of water.
Ingestion Consult a physician if necessary. Rinse mouth.

Fire-fighting measures

Suitable extinguishing media Water, Foam, Dry powder, Carbon dioxide (CO2)
Further information Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Accidental release measures

Environmental precautions Avoid subsoil penetration. Do not flush into surface water or sanitary sewer system.
Methods for cleaning up Use mechanical handling equipment. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust).

Handling and storage

HANDLING
Safe handling advice No special technical protective measures required.
Advice on protection against fire and explosion Normal measures for preventive fire protection.
STORAGE
Requirements for storage areas and containers No special storage conditions required.
Storage classification (VCI system/Germany): 10; Combustible liquids not in Storage Class 3

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all

Additional transport information

Additional transport information
no dangerous good

Exposure controls / personal protection

Respiratory protection No personal respiratory protective equipment normally required. In inadequately ventilated areas, where workplace limits are exceeded, where unpleasant odours exist or where aerosols are in use, or smoke and mist occur, use self-contained breathing apparatus or breathing apparatus with a type A filter or appropriate combined filter (e.g. where aerosols are in use, or smoke and mist occur, A-P2 or ABEK-P2), in compliance with EN 141.

Hand protection:
If protective gloves are used, the glove material must be resistant to the substance.
Check the tightness before wear. Gloves should be well cleaned before being removed, then stored in a well ventilated location. Pay attention to skin care.
Textile or leather gloves are completely unsuitable.

The following materials are suitable for protective gloves (Permeation time >= 8 hours):
Nitrile rubber/Nitrile latex - NBR (0,35 mm)
Following materials are unsuitable for protective gloves:
Natural rubber/Natural latex - NR
Polychloroprene - CR
Butyl rubber - Butyl
Fluoro carbon rubber - FKM
Polyvinyl chloride - PVC

The times listed are suggested by measurements taken at
22 degree C and constant contact. Temperatures raised
by warmed substances, body heat, etc. and a weakening of
the effective layer thickness caused by expansion can lead
to a significantly shorter breakthrough time.
In case of doubt contact the gloves' manufacturer.
A 1.5-times increase / decrease in the layer thickness
doubles / halves the breakthrough time. This data only
applies to the pure substance. Transferred to mixtures of
substances, these figures should only be taken as an aid
to orientation.




Stability and reactivity

Thermal decomposition No decomposition if used as directed.
Hazardous reactions None known.

Disposal considerations

Non-hazardous waste according to Waste Catalogue Ordinance (AVV).
If there is no way of recycling it must be disposed of in compliance with the respective national and local regulations.

Collection of small amounts of substance:
Place in a collection container for halogen-free organic solvents and solutions of halogen-free organic substances.