Registration Dossier
Registration Dossier
Diss Factsheets
Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 201-545-9 | CAS number: 84-61-7
- Life Cycle description
- Uses advised against
- Endpoint summary
- Appearance / physical state / colour
- Melting point / freezing point
- Boiling point
- Density
- Particle size distribution (Granulometry)
- Vapour pressure
- Partition coefficient
- Water solubility
- Solubility in organic solvents / fat solubility
- Surface tension
- Flash point
- Auto flammability
- Flammability
- Explosiveness
- Oxidising properties
- Oxidation reduction potential
- Stability in organic solvents and identity of relevant degradation products
- Storage stability and reactivity towards container material
- Stability: thermal, sunlight, metals
- pH
- Dissociation constant
- Viscosity
- Additional physico-chemical information
- Additional physico-chemical properties of nanomaterials
- Nanomaterial agglomeration / aggregation
- Nanomaterial crystalline phase
- Nanomaterial crystallite and grain size
- Nanomaterial aspect ratio / shape
- Nanomaterial specific surface area
- Nanomaterial Zeta potential
- Nanomaterial surface chemistry
- Nanomaterial dustiness
- Nanomaterial porosity
- Nanomaterial pour density
- Nanomaterial photocatalytic activity
- Nanomaterial radical formation potential
- Nanomaterial catalytic activity
- Endpoint summary
- Stability
- Biodegradation
- Bioaccumulation
- Transport and distribution
- Environmental data
- Additional information on environmental fate and behaviour
- Ecotoxicological Summary
- Aquatic toxicity
- Endpoint summary
- Short-term toxicity to fish
- Long-term toxicity to fish
- Short-term toxicity to aquatic invertebrates
- Long-term toxicity to aquatic invertebrates
- Toxicity to aquatic algae and cyanobacteria
- Toxicity to aquatic plants other than algae
- Toxicity to microorganisms
- Endocrine disrupter testing in aquatic vertebrates – in vivo
- Toxicity to other aquatic organisms
- Sediment toxicity
- Terrestrial toxicity
- Biological effects monitoring
- Biotransformation and kinetics
- Additional ecotoxological information
- Toxicological Summary
- Toxicokinetics, metabolism and distribution
- Acute Toxicity
- Irritation / corrosion
- Sensitisation
- Repeated dose toxicity
- Genetic toxicity
- Carcinogenicity
- Toxicity to reproduction
- Specific investigations
- Exposure related observations in humans
- Toxic effects on livestock and pets
- Additional toxicological data

Eye irritation
Administrative data
- Endpoint:
- eye irritation: in vitro / ex vivo
- Type of information:
- experimental study
- Adequacy of study:
- key study
- Reliability:
- 1 (reliable without restriction)
- Rationale for reliability incl. deficiencies:
- other: GLP study in compliance with international recognized guidelines
Data source
Reference
- Reference Type:
- study report
- Title:
- Unnamed
- Year:
- 2 012
- Report date:
- 2012
Materials and methods
Test guidelineopen allclose all
- Qualifier:
- according to guideline
- Guideline:
- OECD Guideline 437 (Bovine Corneal Opacity and Permeability Test Method for Identifying Ocular Corrosives and Severe Irritants)
- Deviations:
- no
- Qualifier:
- according to guideline
- Guideline:
- other: OECD Guideline 113 Supplement to Test Guidelines 437 and 438: The Bovine Corneal Opacity and Permeability and Isolated Chicken Eye Test Methods: Collection of Tissues for Histopathological Evaluation and Collection of Data on Non severe Irritants.
- Deviations:
- no
- GLP compliance:
- yes
Test material
- Reference substance name:
- Dicyclohexyl phthalate
- EC Number:
- 201-545-9
- EC Name:
- Dicyclohexyl phthalate
- Cas Number:
- 84-61-7
- Molecular formula:
- C20H26O4
- IUPAC Name:
- 1,2-dicyclohexyl benzene-1,2-dicarboxylate
- Test material form:
- other: crystalline powder
Constituent 1
Test animals / tissue source
- Species:
- other: Bovine
- Strain:
- other: not applicable
- Details on test animals or tissues and environmental conditions:
- Slaughter house: Butcher Service s.r.l.- Mattatoio no. 2067 M
St. Teverina Km. 7800 - 01100 Viterbo
Age of animals : 6-12 months
Test system
- Vehicle:
- physiological saline
- Controls:
- other: Physiological saline (0.9% NaCl; BieffeMedital batch no. 10I0208) as a control of the test system.
- Amount / concentration applied:
- 20% (w/v) being the test item a solid non surfactant.
- Duration of treatment / exposure:
- Corneas were exposed in horizontal position for 4 hours ± 5 minutes, incubated in a liquid bath at 32 ± 1°C.
- Number of animals or in vitro replicates:
- 3 corneas for the test item, 3 corneas as negative controls treated with physiological saline 0.9 % NaCl, 3 corneas as positive control treated with imidazole 20% in physiological saline 0.9% NaCl .
- Details on study design:
- The corneas in their holders were incubated in a liquid bath at 32 ± 1°C at least for 1 hour to permit metabolic stabilisation.
At the end of the pre-dose incubation period, the two chambers were drained (anterior first) and re-filled with complete EMEM without phenol red maintained at approximately 32°C (posterior first).
Complete EMEM*
- without phenol red: EMEM* Gibco (Invitrogen) Cat. no. 51200 (batch no. 998577) supplemented with 1% (v/v) Foetal Bovine Serum (FBS - Hyclone - batch no. ATJ33161)
-with phenol red: EMEM* Gibco (Invitrogen) Cat. no. 21090 (batch no. 910192) supplemented with 1% (v/v) Foetal Bovine Serum (FBS - Hyclone - batch no. ATJ33161)
*also named: Minimum Essential Medium Eagle's (MEM) Modified or MEM or Eagle’s MEM.
Examination: Eyes were examined for the presence of any defects which could render the eye unsuitable for use (opacity, scratches or pitting of the corneal surface, vascularisation or pigmentation).
Cornea excision: Each cornea with 2-3 mm of surrounding sclera was dissected from the eye using a scalpel, scissors and forceps and placed into a Petri dish containing HBSS.
Mounting in the chamber: Each cornea was mounted into a prewarmed testing chamber (see Figure 1) with the endothelial surface of the cornea placed in contact with the O-ring of the posterior part of the chamber. Care was taken to ensure the correct position of the cornea minimizing the presence of pigmented area inside the O-ring and avoiding movements which would damage the cornea.
The chamber was then filled with complete EMEM without phenol red maintained at 32 ± 1°C (posterior part of the chamber first to maintain convexity).
Equilibration: The corneas in their holders were incubated in a liquid bath at 32 ± 1°C at least for 1 hour to permit metabolic stabilisation.
At the end of the pre-dose incubation period, the two chambers were drained (anterior first) and re-filled with complete EMEM without phenol red maintained at approximately 32°C (posterior first).
Selection : Basal opacity of corneas was determined by means of a calibrated meter, measuring difference in light transmission between the corneas placed into the beam paths versus air (Opacitometer).
During measurement, attention was paid to keep corneas away from the bath for the minimal time needed.
Corneas with a basal value ≥ 7 arbitrary units are excluded from testing.
The mean opacity of the remaining corneas was determined. Corneas were distributed in treatment groups starting from those nearest to the mean value for the negative control group and trying to approximately maintain opacity values similar to the mean of the negative control group in the treatment and positive control groups.
Results and discussion
In vitro
Resultsopen allclose all
- Irritation parameter:
- cornea opacity score
- Value:
- 0.1
- Negative controls validity:
- valid
- Positive controls validity:
- valid
- Remarks on result:
- other: Basal opacity of corneas was determined by means of a calibrated meter, measuring difference in light transmission between the corneas placed into the beam paths versus air (Opacitometer).
- Irritation parameter:
- other: cornea permeability
- Value:
- 1.67
- Negative controls validity:
- valid
- Positive controls validity:
- valid
- Remarks on result:
- other: Basal opacity of corneas was determined by means of a calibrated meter, measuring difference in light transmission between the corneas placed into the beam paths versus air (Opacitometer).
Applicant's summary and conclusion
- Interpretation of results:
- other: not irritating
- Conclusions:
- The potential of the test item, DICYCLOHEXYLPHTHALATE, to be severely irritant or corrosive to the eye, was measured by its ability to induce opacity and increase permeability in isolated bovine corneas.
No significant alterations of cornea opacity or permeability were recorded during the study when compared to those of negative control.
The negative and positive controls gave the expected results. The test is therefore considered as valid.
According to the OECD Guideline no. 437, the test item is not to be classified as corrosive or severely irritant to the eye.
Moreover, according to the criteria stated in the OECD Supplement to Test Guidelines nos. 437 and 438, there is no indication of irritant effect to the eye. - Executive summary:
The potential of the test item, DICYCLOHEXYLPHTHALATE, to cause corrosion/severe irritation by using the Bovine Corneal Opacity and Permeability (BCOP) assay, was examined in agreement with OECD Guideline no. 437 (adopted on) and OECD Supplement to Test Guidelines nos. 437 and 438.
The test item was tested suspended at 20% (w/v) in physiological saline (being a solid non surfactant) on the epithelial surface of three idoneous bovine corneas, for an exposure period of 4 hours.
Positive and negative controls [a 20% (w/v) Imidazole solution in physiological saline and physiological saline alone, respectively] were concurrently tested in similar condition.
The mean opacity detected with an opacitometer at the end of the test item exposure period was 0.1, comparable to the negative control.
After the determination of opacity, the epithelial surface was treated with a 0.5% solution of sodium fluorescein in DPBS for 90 minutes, to investigate alteration in cornea permeability.Mean OD490value of the corneas treated with the test item was unaffected by treatment, as well as the negative control.Negative and positive controls gave the expected results.
The results obtained indicate that the test item did not induce changes in both cornea opacity and permeability under the reported experimental conditions. The calculated in vitro irritancy score (IVIS) for the test item is 0.
According to the OECD Guideline no. 437, the test item is not to be classified as corrosive or severely irritant to the eye.
Moreover, according to the criteria stated in theOECD Supplement to Test Guidelines nos. 437 and 438, there is no indication of irritant effect to the eye.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.
Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.

EU Privacy Disclaimer
This website uses cookies to ensure you get the best experience on our websites.