Registration Dossier
Registration Dossier
Data platform availability banner - registered substances factsheets
Please be aware that this old REACH registration data factsheet is no longer maintained; it remains frozen as of 19th May 2023.
The new ECHA CHEM database has been released by ECHA, and it now contains all REACH registration data. There are more details on the transition of ECHA's published data to ECHA CHEM here.
Diss Factsheets
Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 255-449-7 | CAS number: 41583-09-9
- Life Cycle description
- Uses advised against
- Endpoint summary
- Appearance / physical state / colour
- Melting point / freezing point
- Boiling point
- Density
- Particle size distribution (Granulometry)
- Vapour pressure
- Partition coefficient
- Water solubility
- Solubility in organic solvents / fat solubility
- Surface tension
- Flash point
- Auto flammability
- Flammability
- Explosiveness
- Oxidising properties
- Oxidation reduction potential
- Stability in organic solvents and identity of relevant degradation products
- Storage stability and reactivity towards container material
- Stability: thermal, sunlight, metals
- pH
- Dissociation constant
- Viscosity
- Additional physico-chemical information
- Additional physico-chemical properties of nanomaterials
- Nanomaterial agglomeration / aggregation
- Nanomaterial crystalline phase
- Nanomaterial crystallite and grain size
- Nanomaterial aspect ratio / shape
- Nanomaterial specific surface area
- Nanomaterial Zeta potential
- Nanomaterial surface chemistry
- Nanomaterial dustiness
- Nanomaterial porosity
- Nanomaterial pour density
- Nanomaterial photocatalytic activity
- Nanomaterial radical formation potential
- Nanomaterial catalytic activity
- Endpoint summary
- Stability
- Biodegradation
- Bioaccumulation
- Transport and distribution
- Environmental data
- Additional information on environmental fate and behaviour
- Ecotoxicological Summary
- Aquatic toxicity
- Endpoint summary
- Short-term toxicity to fish
- Long-term toxicity to fish
- Short-term toxicity to aquatic invertebrates
- Long-term toxicity to aquatic invertebrates
- Toxicity to aquatic algae and cyanobacteria
- Toxicity to aquatic plants other than algae
- Toxicity to microorganisms
- Endocrine disrupter testing in aquatic vertebrates – in vivo
- Toxicity to other aquatic organisms
- Sediment toxicity
- Terrestrial toxicity
- Biological effects monitoring
- Biotransformation and kinetics
- Additional ecotoxological information
- Toxicological Summary
- Toxicokinetics, metabolism and distribution
- Acute Toxicity
- Irritation / corrosion
- Sensitisation
- Repeated dose toxicity
- Genetic toxicity
- Carcinogenicity
- Toxicity to reproduction
- Specific investigations
- Exposure related observations in humans
- Toxic effects on livestock and pets
- Additional toxicological data
Acute Toxicity: inhalation
Administrative data
- Endpoint:
- acute toxicity: inhalation
- Type of information:
- experimental study
- Adequacy of study:
- key study
- Study period:
- 1998
- Reliability:
- 2 (reliable with restrictions)
- Rationale for reliability incl. deficiencies:
- guideline study with acceptable restrictions
Data source
Reference
- Reference Type:
- study report
- Title:
- Unnamed
- Year:
- 1 998
- Report date:
- 1998
Materials and methods
Test guideline
- Qualifier:
- according to guideline
- Guideline:
- OECD Guideline 403 (Acute Inhalation Toxicity)
- GLP compliance:
- yes (incl. QA statement)
- Test type:
- standard acute method
- Limit test:
- yes
Test material
- Reference substance name:
- Melamine
- EC Number:
- 203-615-4
- EC Name:
- Melamine
- Cas Number:
- 108-78-1
- Molecular formula:
- C3H6N6
- IUPAC Name:
- 1,3,5-triazine-2,4,6-triamine
Constituent 1
Test animals
- Species:
- rat
- Strain:
- Wistar
- Remarks:
- Crl:[WI]WU BR
- Sex:
- male/female
- Details on test animals or test system and environmental conditions:
- TEST ANIMALS
- Source: Charles River Wiga, Sulzfeld, Germany
- Females (if applicable) nulliparous and non-pregnant: [yes/no]
- Age at study initiation: 6 - 7 weeks at the time of delivery
- Housing: Suspended stainless steel cages with wire mesh floor and front
- Diet (e.g. ad libitum): Rat & Mouse No. 3 Breeding diet RM3 from SDS Special Diets Services, Witham, England. Each batch of this diet is analysed by SDS for nutrients and contaminants.
- Water (e.g. ad libitum):Tap water suitable for human consumption, supplied by N.V. Waterleidingbedrijf Midden-Nederland (WMN). Water samples are periodically analysed by WMN.
- Acclimation period: 9 days
ENVIRONMENTAL CONDITIONS
- Temperature (°C): 20.0- 22.5
- Humidity (%): 40- 66 %.
- Air changes (per hr): 10
- Photoperiod (hrs dark / hrs light): 12/12
Administration / exposure
- Route of administration:
- inhalation: aerosol
- Type of inhalation exposure:
- nose only
- Vehicle:
- air
- Details on inhalation exposure:
- Exposure chamber
Animals were exposed to the test atmosphere in a nose-only inhalation chamber, a modification of the chamber manufactured by ADG Developments Ltd., Codicote, Hitchin, Herts, SG4 8UB, United Kingdom. The inhalation chamber consisted of a cylindrical aluminium column, surrounded by a transparent cylinder.
The column had a volume of ca. 50 L and consisted of a top assembly with two mixing chambers, underneath a rodent tube section and the exhaust section at the bottom. The rodent tube section had 20 ports for animal exposure. Several empty ports were used for test atmosphere sampling, particIe size analysis, measurement of oxygen concentration, temperature and relative humidity. The animals were secured in plastic animal holders (BatteIIe), positioned radially through the outer cylinder around the central column. Male and female rats of each group were placed in alternating order. The remaining ports were closed. Only the nose of the rats protruded into the interior of the column.
By securing a positive pressure in the central column and a slightly negative pressure in the outer cylinder, which encloses the entire animal holder, air leaks from nose to thorax rather than from thorax to nose and dilution of test atmosphere at the nose of the animals is prevented.
Generation of the test atmosphere
The inhalation equipment was designed to expose rats to a continuous supply of fresh test atmosphere. The test atmosphere was generated by passing the test material using a dry material helix feeder (Hethon, Hengelo, the Netherlands) to a jet mill (Institute's design). In order to guarantee a non-fluctuating output a stirring-rod was used within the helix feeder whereas a vibration device was placed just before the entrance to the jet milI. The jet mill was operated with dry pressurized air (Iess than 1% humidity); the test material was delivered using a slip stream of air conditioned room air.
In first instance, water mist produced by an ultrasonic nebulizer was added to obtain relative humidity values slightly above 30% to satisfy the required range of 30-70%. Using this set-up, however, the concentration dropped from nearly 5 g/m3 to about 2 g/m3 which was far below the required concentration (viz. > 5 g/m3).
Because of this concentration drop it was decided not to add water mist and to accept a low relative humidity to obtain the limit concentration of 5 g/m3. In addition, a particle size distribution measurement showed that particles were relatively large, viz. an MMAD of 6.2 µm with a geometric standard deviation of 1.9 was obtained. Apparently, although a jet mill was used to break up agglomerated particles, it was not sufficient to generate a test atmosphere consisting of respirable particles only (viz. almost 100% smaller than 5 µm, or with an MMAD of between 1 and 4 µm). However, since it was not expected to obtain higher numbers of smaller particles using other dispersing devices without possibilities to break up agglomerates, a jet mill was used during the present study.
Before exposure, the rate of airflow through the exposure unit was established at the input pressures used (5.0 bar for both jet and mill). During exposure, the pressure settings were recorded at regular intervals (approximately each half hour).
In this way, the total airflow was monitored indirectly through the aerosol generation system. The average amount of air passed through the exposure unit was 99.2 L/min including about 28 L/min from the slip stream. The concentration of the aerosol was controlled by the output of the feeder which was measured twice at three different settings the day after exposure. During exposure, the setting of the feeder was recorded at regular intervals (approximately each half hour) and at changes.
The generated aerosol was passed to the inlet of the exposure unit and directed downward through the mixing sections towards the animaIs. At the bottom of the unit the test atmosphere was exhausted. The period between the start of the generation of the test atmosphere and the start of exposure of the animals was 111 min.
Analysis of the test atmosphere
The actual concentrations in the test atmosphere were determined eight times (about twice per hour) by gravimetric analysis. Representative samples were obtained by passing 5 L test atmosphere samples at 5 L/min through fibre glass filters (Sartorius). Filters were weighed before sampling, loaded with aerosol particles, and finally weighed again. The actual concentration was calculated by dividing the amount of test material captured by the volume of the air sample taken.
The nominal concentration was determined by dividing the total amount of test material used by the total volume of air passed through the exposure unit.
ParticIe size distribution measurements were carried out once during preliminary testing and once during exposure using a 10-stage cascade impactor (Anderssen, Atlanta, USA) with the largest cut-off size of 32 µm. The Mass Median Aerodynamic Diameter (MMAD) and the mean geometric standard deviation (gsd) were calculated.
The temperature of the test atmosphere was recorded eight times during exposure at regular intervals (about twice per hour) using a RH/T device (TESTO 610, GmbH & Co, Lenzkirch, Schwarzwald, Germany). The oxygen concentration was checked once during exposure (Beryl, Cosma, Igny, France). - Analytical verification of test atmosphere concentrations:
- yes
- Duration of exposure:
- 4 h
- Concentrations:
- 5.19 g/m³
- No. of animals per sex per dose:
- 5
- Control animals:
- no
- Details on study design:
- The rats were visually inspected just before exposure, for reactions to treatment during the exposure, shortly after exposure, and at least once daily during the observation period.
Body weights were recorded just prior to exposure (day 0), and on days 7 and 14.
At the end of the 14-day observation period, all rats were killed by exsanguination from the abdominal aorta under ether anaesthesia. All rats were necropsied and examined for gross pathological changes. - Statistics:
- none
Results and discussion
Effect levels
- Key result
- Sex:
- male/female
- Dose descriptor:
- LC50
- Effect level:
- > 5 190 mg/m³ air (analytical)
- Based on:
- test mat.
- Exp. duration:
- 4 h
- Mortality:
- No mortalities during exposure to the test item or during the observation period.
- Clinical signs:
- other: Changes in breathing pattern: Slightly decreased breathing frequency in all animals during the first hour of exposure, followed by moderately decreased breathing rate during the remaining exposure period. 1 hour after exposure blepharospasm was observed i
- Body weight:
- Overall body weight gain was considered to be normal for rats of this strain and age.
- Gross pathology:
- In all animals lung changes were noted: One or more petechiae in all males and one female, grey (and/or pale) discolouration in one male and three females, and white spots in one male and two females.
Thymic changes were observed in one male: Unilateral red thymus - Other findings:
- none
Any other information on results incl. tables
Analytical results
The actual concentration of Melamine during the exposure based on gravimetric analyses is given in Table 1. The mean measured concentration during exposure was 5.19 +/- 0.45 g/m³. The nominal concentration during exposure was calculated to be 12.3 g/m³, indicating a generation efficiency of 42%. The particle size distribution is given in Table 2. Ca. 66% of the particles present at the animals breathing zone had an aerodynamic diameter equal to or smaller than 8.2 µm, whereas ca. 35 % equal to or smaller than 5.0 µm. The Mass Median Aerodynamic Diameters (MMAD) was 6.6 µm with a mean geometric standard deviation of 2.5. These data were essentially the same as obtained during preliminary testing: an MMAD of 6.2 µm with a mean geometric standard deviation of 1.9. The mean temperature during exposure was 20.9 +/- 0.2 °C (range 20.7-21.2 °C), the mean relative humidity was 28 +/- 4% (range 22-32 %) and the oxygen concentration was 21.4 %.
Applicant's summary and conclusion
- Interpretation of results:
- GHS criteria not met
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.
Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.