Registration Dossier

Physical & Chemical properties

Endpoint summary

Administrative data

Description of key information

Appearance

The test material was observed to be an amber coloured liquid.

 

Melting/freezing point

The pour point of an analogue test item was determined to be -9 ± 3 °C (264 ± 3 K) (OECD 102 and EU Method A.1).

 

Boiling point

When investigated using differential scanning calorimetry, an analogue test item was determined to undergo self-reaction from approximately 118 °C (391 K) at 102 kPa followed by partial boiling (approximately 75%) from approximately 227 °C (500 K). As a result of the reaction, no value for the boiling point of the original components of the test item could be determined (OECD 103 and EU Method A.2).

Relative density

Density of an analogue test item was determined to be 1.02 x 10E03 kg/m3 at 20.0 ± 1.0 °C using the pycnometer method and the relative density was reported as 1.02 (OECD 109 and EU Method A.3).

 

Granulometry

Determination of particle size distribution is not relevant because the substance is not marketed or used in solid or granular form.

 

Vapour pressure

The vapour pressure of an analogue test item was determined to be 0.1 Pa at 25 °C (298 K) and 15.0 Pa at 80 °C (353 K) (OECD 104 and EU Method A.4).

Partition coefficient

The Pow value of the test item was determined to be > 2.16 x 10E+04, which corresponds to a Log Pow value of > 4.3 using the estimation method (EU Method A.8).

 

Water solubility

With a nominal loading rate of 0.05 g/L, water solubility of the test item was determined by the flask method and LC-MS analysis to be 1.56 x 10E-02 g/L at 20.0 ± 0.5 °C. With a nominal loading rate of 0.2 g/L, water solubility of the test item was determined by the flask method and LC-MS analysis to be 4.64 x 10E-02 g/L at 20.0 ± 0.5 °C (OECD 105 and EU Method A.6).

Surface tension

The surface tension of analogue test item solutions prepared at nominally 1.1 g/L of test item in water and diluted to 90 % saturation was determined to be 48.1 mN/m at 21.5 ± 0.5 °C and the substance was considered to be surface-active (OECD 115 and EU Method A.5).

 

Flash point

The flashpoint of an analogue test item was determined to be 143 ± 2 °C (EU Method A.9).

Autoflammability

An analogue test item was determined to have an autoignition temperature of 332 ± 5 °C (EU Method A.15).

 

Flammability

Source and target substances are liquids and, in line with ECHA Guidance on Information Requirements and Chemical Safety Assessment Chapter R.7a: Endpoint specific guidance (Version 5.0; December 2016), relevant properties for classification of the substances as flammable are the determined flash point and boiling point. Further experimental investigation of flammability is therefore not required.

 

Explosive properties

The result for explosive properties of an analogue test material was predicted negative based on the chemical structure of the test item (EU Method A.14).

 

Oxidising properties

The result for oxidising properties of an analogue test item was predicted negative based on the chemical structure of the test item (EU Method A.21).

Additional information