Registration Dossier

Administrative data

First-aid measures

General advice
Take care of your own personal safety.
Remove victims from hazardous area.
Take off all contaminated clothing immediately.
Keep patient warm and at rest.
Do not leave victims unattended.
Inhalation
Move victims into fresh air.
Place person on side in stable position if unconscious until medical assistance arrives or the patient can be transported to a medical facility for treatment and evaluation.
In case of difficulties in breathing, supply oxygen.
Employ artificial respiration if breathing ceases.
Consult a physician immediately.
Skin contact
In the event of frostbite, rinse copiously with water.
Do not remove clothing that adheres due to freezing.
Cover with sterile dressing and seek medical advice.
Eye contact
Flush affected eye immediately with water at ambient temperature.
Do not force eyelids open.
Consult an ophthalmologist.
Ingestion
Ingestion by swallowing is not considered a possible mode of exposure.
Notes to physician
Oxygen-displacing gas.
No specific antidote known.
cardio-vascular monitoring.
Symptomatic treatment.

Fire-fighting measures

Suitable extinguishing media
CO2, dry powder
Extinguishing media which must not be used for safety reasons
high volume water jet
Specific hazards during fire fighting
Closed container may rupture if strongly heated.
In case of fire cool endangered containers with water.
Heavier than air vapour.
Formation of flammable or explosive vapour/air mixtures possible.
Keep all ignition sources out of area
Special protective equipment for fire-fighters
wear a self contained respiratory apparatus
full protective suit, if necessary

Accidental release measures

Personal precautions
Wear personal protective equipment; see section 8.
Avoid contact with skin and eyes.
Do not inhale vapours / aerosols.
Leave room immediately.
Heavier than air vapour.
Ensure adequate ventilation.
Ensure good room ventilation at floor level too.
Keep away from sources of ignition - No smoking.
Environmental precautions
Do not allow entrance in sewage water, drainage systems, stretches of water, soil.
Avoid penetration into drainage system or in rooms situated at a lower level because of danger of explosion.
Methods for cleaning up
taking special safety precautions
Confine and allow to evaporate.

Handling and storage

Handling
Safe handling advice
Wear personal protective equipment; see section 8.
Avoid contact with skin and eyes.
Do not inhale vapours / aerosols.
Provide good ventilation or extraction.
Ensure good room ventilation at floor level too.
Priority should be given to closed-system units.
Observe special instructions applicable to compressed gases.
Advice on protection against fire and explosion
Take precautionary measures against static charges, keep away from sources of ignition.
Explosion protection equipment required.
Temperature class
T 2
Storage
Requirements for storage areas and containers
Keep containers tightly closed in a cool, well-ventilated place.
With exclusion of air/oxygen
Suitable materials stainless steel, Unalloyed steel
Unsuitable materials aluminium, copper and their alloys
Advice on common storage
Observe prohibition against storing together!
Storage stability
< 50 °C
Recommended storage temperature

Transport information

Land transport (ADR/RID)

UN number:
1010
Shippingopen allclose all
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

UN number:
1010
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all

Air transport ICAO/IATA

UN number:
1010
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Engineering measures
If contact with gases or vapours cannot be excluded: Provide good ventilation or extraction.
Priority should be given to closed-system units.
Occupational exposure controls
Further information
ACGIH (American Conference of Governmental Industry Hygienists)
Personal protective equipment
Respiratory protection
In case of dusts/vapours/aerosols being formed or if the limit values like TLV are exceeded:
If concentrations in the breathed air are low:
Respirator with brown AX-type filter
Put on Respiratory protective equipment independent of surrounding air with high gas/vapour concentrations.
Hand protection
Chemical-resistant protective gloves (EN 374)
Glove material suitable protective gloves e.g. nitrile-butadiene rubber (NBR) gloves, heat insulating
Selection of protective gloves to meet the requirements of specific workplaces.
Suitability for specific workplaces should be clarified with protective glove manufacturers.
The information is based on our own tests, references from the literature and information from glove manufacturers, or derived by analogy with similar materials.
Remember that the useful time per day of a chemical protection glove may be much shorter than the permeation time determined according to EN 374 due to the many different influential factors involved (e.g. temperature).
Eye protection
close-fitting protective goggles (e.g. closed goggles) or face protection
Skin and body protection
Select materials and equipment for physical protection depending on the concentration and volume of hazardous substances and the workplace involved.
Hygiene measures
Do not inhale vapours / aerosols.
Remove contaminated or saturated clothing.
Smoking, eating and drinking should be prohibited in the application area.
Wash face and/or hands before break and end of work.
Use barrier cream regularly.
Protective measures
Wear suitable protective clothing.
full protective suit, if necessary

Stability and reactivity

Conditions to avoid
Keep away from heat and sources of ignition.

Materials to avoid
strong oxidizing agents, oxygen

Hazardous decomposition products
not known

Thermal decomposition
Explosive decomposition caused by external ignition sources at temperatures of above 70'C and a pressure of more than 7 bar.

Hazardous reactions
Formation of flammable or explosive vapour/air mixtures possible.

Disposal considerations

With respect to local regulations, e.g. incineration via flare system.
No waste key number as per the European Waste Types List can be assigned to this product, since such classification is based on the (as yet undetermined) use to which the product is put by the consumer.
The waste key number must be determined as per the European Waste Types List (decision on EU Waste Types List 2000/532/EC) in cooperation with the disposal firm / producing firm / official authority.