Registration Dossier

Administrative data

First-aid measures

Inhalation: Remove to fresh air. If not breathing give artificial respiration. If breathing is difficult, give oxygen.
Skin contact: Wash off with plenty of water and soap for at least 15 minutes. Remove contaminated clothing and shoes. If irritation occurs or persists, get medical attention. Wash clothing and shoes before reuse.
Eye contact: Rinse out with plenty of water for at least 15 minutes with the eyelid held wide open. Call a physician.
Ingestion: Wash out mouth with water provided person is conscious. Call a physician.

In any case seek medical advice and call the nearest poison centre.

Fire-fighting measures

Suitable extinguishing media: All common extinguishing media are suitable. Water spray, carbon dioxide, dry chemical powder, foam.
Special fire-fighting procedures: NIOSH approved positive pressure. Wear self-contained breathing apparatus and full protective turnout gear.
Unusual fire and explosions hazards: Dust can combine with air to form an explosive mixture.
Other information: May produce toxic fumes of carbon monoxide, carbon dioxide and nitrogen oxide. The composition of the combustion products hase not been determined. Prevent fire-fighting water from entering surface water or groundwater.

Accidental release measures

Person-related precautionary measures: Evacuate area. Wear self-contained breathing apparatus, chemical safety goggles, rubber boots and heavy rubber gloves. Wear disposable coveralls and discard them after use.
Environmental-protection measures: Do not allow to enter sewerage system.
Procedures for cleaning / absorption: Ventilate area and wash spill site after material pickup is complete. Cover with dry lime or soda ash, pick up, keep in a closed container and hold for waste disposal.

Handling and storage

Handling
Avoid contact with skin and eyes.
Storage
Store in dry, cool, well-ventilated area.
Mechanical ventilation is recommended.
Local exhaust is needed at source of vapours.
Local ventilation is needed at bulk vessel openings.

Transport information

Land transport (ADR/RID)

UN number:
not classified
Shippingopen allclose all
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

UN number:
not classified
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

UN number:
not classified
Remarksopen allclose all

Air transport ICAO/IATA

UN number:
not classified
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment: Protective clothing should be selected specifically for the working place, depending on concentration and quantity of the hazardous substances handled. The resistance of the protective clothing to chemicals should be ascertained with the respective supplier.
Respiratory protection: Is required whenever air contamination (dust, mist, or vapors) is generated by the process. A NIOSH-approved high efficiency toxic dust/mist/fume respirator is recommended.
Eye protection: required Hand protection: In full and splash contact:
Glove material: PVC, Butyl-/Nitrile rubber
Layer thickness: 0.11 mm
The protective gloves to be used must comply with the specifications of EC directive 89/686/EEC and the resultant standard EN374.
This recommendation applies only to the product stated in the safe data sheet and supplied by us as well as to the purpose specified by us.
When dissolving in or mixing with other substances and under conditions deviating from those stated in EN374 please contact the supplier of CE-approved gloves.
Industrial hygiene: Immediately change contaminated clothing. Wash thoroughly after handling. General room ventilation is adequate unless the process generates dust or fumes. Work clothing should be removed in a change room on site and laundered professionally. Employees should shower and change into streetclothes before leaving the facility. Prevent the accumulation of dust in the work area by thorough periodic cleaning of the area.

Environmental exposure controls and protective equipment:
Water: Do not release into water. If in waste water, waste water treatment is required.
Air: For industrial and professional uses air-filters may be required.
Soil: Do not release into the soil.

Stability and reactivity

General Stability considerations: Stable at room temperature Conditions to be avoided: Light and elevated temperature Substances to be avoided: Oxidizing agents Hazardous combustion or decomposition products: Carbon monoxide, carbon dioxide, nitrogen oxides Further information: Hazardous polymerization does not occur.

Disposal considerations

Product: Dissolve or mix with combustible solvent and burn in an incinerator with afterburner and scrubber in accordance with local, state and federal regulations.
Packaging: Disposal in compliance with official regulations. Handle contaminated packaging in the same way as the substance itself.