Registration Dossier

Administrative data

First-aid measures

Emergency measure - Inhalation: If gas/fume/vapor/mist from the material is inhaled, remove
the affected person immediately to fresh air. Seek medical
attention.
Emergency measure - Eyes: Immediately flush eyes with water for at least 15 minutes,
while holding eyelids open. Get medical attention or advice.
Emergency measure - Skin: For skin contact flush with large amounts of water while
removing contaminated clothing. Get medical attention. Wash
clothing before reuse.
Emergency measure - Ingestion: Do not induce vomiting. Get medical attention immediately.
Prevent aspiration of material into lungs.

Fire-fighting measures

Recommended extinguishing agent: In case of fire use carbon dioxide, powder or dry sand.

Product arising from burning: The substance is combustible and will burn if involved in a
fire, evolving noxious fumes (eg carbon oxides).

Product determined by test: N

Protective equipment: Full protective clothing and self-contained breathing
apparatus must be worn.


Fight the fire from a safe distance or protected location.

Accidental release measures

Emergency measures in case of spillage: Evacuate personnel from immediate vicinity.


Wear appropriate personal protective equipment conforming to
the relevant national or international standards, as
mentioned in section 2.3.00.


Remove sources of ignition, ventilate the contaminated area
and block any potential routes to the water systems.



Absorb spillages of solutions with a suitable inert
material (eg. sand or soil). Carefully transfer the spillage
to waste containers, or use a sealed

industrial vacuum machine. Containers filled with waste
material must be labelled in the same way as the original
substance containers.


Clean the spillage area with water.



Dispose of waste material in accordance with local
regulations by incineration.

Handling and storage

Handling: The substance should be stored, handled and used under
conditions of good industrial hygiene and in conformity with
any local regulations in order to avoid exposure.


Engineering controls are necessary to reduce exposure to the
substance. Ventilation should effectively remove and
prevent build-up of any vapour or mist generated from the
handling of this product.


Containers should be bonded and grounded during transfer of
material.


When exposure cannot be prevented or adequately controlled
appropriate personal protective equipment should be worn.

Such protective equipment should conform to the appropriate
international or national standards as follows;

Chemical protective gloves to Standard EN374

Chemical protective clothing to Standard EN368

Eye protection to Standard EN166.


Furthermore, when respiratory protective equipment has to be
used, it must be capable of adequately controlling
exposure, be suitable for the purpose, and conform to the
appropriate international or national standards, such as a
dust mask conforming to EN136.


These measures should be regarded as a minimum.

Storage: Store in a cool, dry, and well-ventilated area. Store in
combustible storage area and away from heat and open flame.
Avoid storing containers in direct sunlight as vapors may
accumulate in the head space creating pressure. Do not store
in open, unlabeled or mislabeled containers. Keep container
closed when not in use. Keep container upright, when not in
use, to prevent leakage. Open containers carefully and
slowly. Do not cut, puncture or weld on or near the
containers. Do not apply pressure to containers. Emptied
container may contain residual vapors or liquid which may
ignite or explode. Do not reuse empty container without
commercial cleaning or reconditioning.

Packaging of the substance and or preparation: HDPE bottles, 1-5 litres

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all

Air transport ICAO/IATA

Remarks
Transport code: UN1993
Transport: Shipping Name: Flammable liquids, n.o.s. (2-Heptanone,
Toluene, Mixture)

Hazard Class: 3

Packing Group: III

Required Label(s): FLAMMABLE LIQUID


Avoid crushing the containers. Seal the container and

transport in normal temperature avoiding breakage.


In the event of a spillage, observe the warning labels on
the container.
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Stability and reactivity

Danger other than fire: Hot vapor or mists may be susceptible to spontaneous
combustion when mixed with air. Ignition temperatures
decrease with increasing vapor volume and vapor/air contact
time and are influenced by pressure changes. Therefore,
ignition may occur below published ignition temperatures.


Exposing closed containers to heat may cause excessive
pressure resulting in explosive rupture.

Chemical reaction with water: None which is hazardous.

Dust explosion: Under normal conditions of use this material does not
present a significant explosion hazard. However, like most
organic compounds it is combustible and may form a dust
explosion if widely dispersed in air.

Dust explosion determined by test: N

Disposal considerations

Industry - Possibility of recovery/recycling: Discharge to the environment will be minimal. Recovery from
minor spillages or accidental discharge is not economically
or technically feasible, and such waste material will be
disposed of by incineration or landfill. In principle, it
may be possible to recover larger spillages of
uncontaminated material for subsequent use.

Industry - Possibility of neutralisation: The notification tests have shown that the substance is not
provisionally classified at the VIID Reduced Test Package
notification level.

Industry - Possibility of destruction: controlled discharge: Contaminated containers or spillages of solutions mixed
with inert material (eg. sand or soil) may be disposed of by
landfill at an authorised tip in accordance with local
regulations.

Industry - Possibility of destruction - incineration: The substance can be disposed of by incineration by burning
under controlled conditions at a licensed waste treatment
processor in accordance with local regulations. Stack gases
should be scrubbed, because noxious fumes (eg. carbon
oxides) could be formed.

Industry - Possibility of destruction - water purification: The substance should not normally be discharged directly to
the sewage system or the aqueous environment. However,
adverse effects on sewage treatment systems would be
unlikely.

Industry - Possibility of destruction - other: None.

Public at large - Possibility of recovery/recycling: Not applicable as the substance will not be made available
to the public at large.

Public at large - Possibility of neutralisation: Not applicable as the substance will not be made available
to the public at large.

Public at large - Possibility of destruction: controlled discharge: Not applicable as the substance will not be made available
to the public at large.

Public at large - Possibility of destruction - incineration: Not applicable as the substance will not be made available
to the public at large.

Public at large - Possibility of destruction - water purification: Not applicable as the substance will not be made available
to the public at large.

Public at large - Possibility of destruction - others: None.