Registration Dossier

Diss Factsheets

Administrative data

First-aid measures

General advice:

Remove contaminated clothing. If danger of loss of consciousness, place patient in recovery position

and transport accordingly. Apply artificial respiration if necessary. First aid personnel should pay

attention to their own safety.

If inhaled:

If difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and seek medical

attention.

On skin contact:

Wash thoroughly with soap and water.

On contact with eyes:

Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open,

consult an eye specialist.

On ingestion:

Rinse mouth immediately and then drink plenty of water, seek medical attention.

Note to physician:

Treatment: Treat according to symptoms (decontamination, vital functions), no known specific

antidote.

Fire-fighting measures

Suitable extinguishing media:

water spray, dry extinguishing media, alcohol-resistant foam, carbon dioxide

Special protective equipment:

Wear self-contained breathing apparatus and chemical-protective clothing.

Further information:

Collect contaminated extinguishing water separately, do not allow to reach sewage or effluent

systems. Keep containers cool by spraying with water if exposed to fire. Foam should be applied in

large quantities as it is broken down to some extent by the product.

Accidental release measures

Personal precautions:

Avoid inhalation. Avoid contact with the skin, eyes and clothing.

Environmental precautions:

Discharge into the environment must be avoided.

Methods for cleaning up or taking up:

For large amounts: Pump off product.

For residues: Pick up with suitable absorbent material (e.g. sand, sawdust, general-purpose binder,

kieselguhr). Dispose of absorbed material in accordance with regulations.

Handling and storage

Handling

Ensure thorough ventilation of stores and work areas.

Protection against fire and explosion:

Prevent electrostatic charge - sources of ignition should be kept well clear - fire extinguishers should

be kept handy.

Storage

Further information on storage conditions: Keep container tightly closed and dry; store in a cool

place.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment

Respiratory protection:

Wear respiratory protection if ventilation is inadequate. Gas filter for gases/vapours of organic compounds (boiling point >65 °C, e. g. EN 14387 Type A)

Hand protection:

Chemical resistant protective gloves (EN 374)

Suitable materials also with prolonged, direct contact (Recommended: Protective index 6, corresponding > 480 minutes of permeation time according to EN 374):

butyl rubber (butyl) - 0.7 mm coating thickness

nitrile rubber (NBR) - 0.4 mm coating thickness

Supplementary note: The specifications are based on tests, literature data and information of glove manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g. temperature) it must be considered, that the practical usage of a chemical-protective glove in

practice may be much shorter than the permeation time determined through testing.

Manufacturer's directions for use should be observed because of great diversity of types.

Eye protection:

Tightly fitting safety goggles (splash goggles) (e.g. EN 166)

Body protection:

Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case of dust).

General safety and hygiene measures:

Avoid contact with the skin, eyes and clothing. Avoid inhalation of vapour. Wearing of closed work clothing is required additionally to the stated personal protection equipment.

Occupational Exposure Limit

RM-Freetext: Exceeding factor: 1.

Occupational Exposure Limit

RM-Freetext: If the MAK and BAT values are complied with, there should be no risk for the fetus.

Occupational Exposure Limit

SO-Freetext: TRGS 900 (Germany), 08/2004

Occupational Exposure Limit

Type of limit MAK (DE) 310 mg/m3

Stability and reactivity

Stability and reactivity

Hazardous reactions:

Reacts with strong oxidizing agents.

Disposal considerations

Disposal considerations

Must be dumped or incinerated in accordance with local regulations.

Contaminated packaging:

Contaminated packaging should be emptied as far as possible; then it can be passed on for recycling after being thoroughly cleaned.