Registration Dossier
Registration Dossier
Diss Factsheets
Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 413-910-1 | CAS number: 1467668-33-2 LUPEROX 610-E-35; LUPEROX 610-E-50; LUPEROX 610-EN-50; LUPEROX 610-M-50; LUPERSOL 610; LUPERSOL 610-M-50
- Life Cycle description
- Uses advised against
- Endpoint summary
- Appearance / physical state / colour
- Melting point / freezing point
- Boiling point
- Density
- Particle size distribution (Granulometry)
- Vapour pressure
- Partition coefficient
- Water solubility
- Solubility in organic solvents / fat solubility
- Surface tension
- Flash point
- Auto flammability
- Flammability
- Explosiveness
- Oxidising properties
- Oxidation reduction potential
- Stability in organic solvents and identity of relevant degradation products
- Storage stability and reactivity towards container material
- Stability: thermal, sunlight, metals
- pH
- Dissociation constant
- Viscosity
- Additional physico-chemical information
- Additional physico-chemical properties of nanomaterials
- Nanomaterial agglomeration / aggregation
- Nanomaterial crystalline phase
- Nanomaterial crystallite and grain size
- Nanomaterial aspect ratio / shape
- Nanomaterial specific surface area
- Nanomaterial Zeta potential
- Nanomaterial surface chemistry
- Nanomaterial dustiness
- Nanomaterial porosity
- Nanomaterial pour density
- Nanomaterial photocatalytic activity
- Nanomaterial radical formation potential
- Nanomaterial catalytic activity
- Endpoint summary
- Stability
- Biodegradation
- Bioaccumulation
- Transport and distribution
- Environmental data
- Additional information on environmental fate and behaviour
- Ecotoxicological Summary
- Aquatic toxicity
- Endpoint summary
- Short-term toxicity to fish
- Long-term toxicity to fish
- Short-term toxicity to aquatic invertebrates
- Long-term toxicity to aquatic invertebrates
- Toxicity to aquatic algae and cyanobacteria
- Toxicity to aquatic plants other than algae
- Toxicity to microorganisms
- Endocrine disrupter testing in aquatic vertebrates – in vivo
- Toxicity to other aquatic organisms
- Sediment toxicity
- Terrestrial toxicity
- Biological effects monitoring
- Biotransformation and kinetics
- Additional ecotoxological information
- Toxicological Summary
- Toxicokinetics, metabolism and distribution
- Acute Toxicity
- Irritation / corrosion
- Sensitisation
- Repeated dose toxicity
- Genetic toxicity
- Carcinogenicity
- Toxicity to reproduction
- Specific investigations
- Exposure related observations in humans
- Toxic effects on livestock and pets
- Additional toxicological data

Endpoint summary
Administrative data
Description of key information
Additional information
When released in water
The determination of the hydrolysis as a function of pH was based on EEC Directive C.10 "Abiotic degradation: Hydrolysis as a function of pH"(1984). At pH 4, 7 and 9, a decrease in concentration > 50% was observed after 2.4 hours (half-life time < 2.4 hours). Hence it was concluded that the concerned substance is hydrolytically unstable at pH 4, 7 and 9,under the conditions of the test. The test was performed at 50.0 ± 0.5°C.
Biodegradation
The ready biodegradability of 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate was evaluated in a study performed in accordance with OECD testing guideline 301 B (Bogers, 1993).
The relative degradation values calculated from the measurements performed during the test period showed a slight degradation at 10 mg/L (16%) but no significant biodegradation at 20 mg/L (4.4%). However, since the substance is hardly soluble in water, the lack of microbial degradation could be a consequence of the limited availability for micro-organisms. Thus under the conditions of this test, 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate was not readily biodegradable.
A study according to OECD guideline 309 and GLP requirements has been performed in order to determine the extent of mineralisation of 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate in a natural surface water at 20 ± 2°C and to determine its route and rate of degradation under the test conditions (Lewis, 2016).
Two radiolabelled forms of 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate have been used in the study: [hexylene glycol-4 - 14C]3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate and [2 -14C-methylheptanoate] 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate.
Two test concentrations were used for each radiolabel (10 and 95 µg/L). Sodium [14C] benzoate was used as a reference substance.
Under these conditions, the test substance mineralised rapidly; mineralisation rates were very similar for each concentration and were also similar between radiolabels (DT-50 values were 8-10 days).No significant mineralisation occurred under sterile conditions.
Primary degradation occurred by hydrolysis and probably also microbially to produce transient degradation products in the aqueous phase which, themselves, were rapidly mineralised. There were four major (> 10% AR) degradation products present in the water phase, two from each half of the molecule, and a further two degradation products at ca 10% AR detected only after treatment with the hexylene glycol label. There were no degradation products present at > 10% AR in the water phase by the end of the study (59 DAT).
The DT-50 for the test substance in the water, determined by SFO kinetics, was ca 0.6 days and the DT-50 values for the degradation products in the water phase were in the approximate range of 2-14 days, except for one degradation product detected from the hexylene glycol label that had an apparently longer DT-50 value. Although degradation rates were only determined at the higher of the two application rates, the mineralisation rates were not concentration dependent and therefore the primary degradation rates must also have been similar.
As a conclusion, neither 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate or its degradation products are likely to persist in natutal aerobic water systems.
When released in soil
A study was performed to estimate the adsorption coefficient (Koc) of 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate by HPLC. A log10Kocvalue of 3.3 (equivalent Koc= 2100) has been determined.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.
Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.

EU Privacy Disclaimer
This website uses cookies to ensure you get the best experience on our websites.