Registration Dossier

Administrative data

First-aid measures

In case of inhalation
- Negligible or unlikely exposure pathways
- If breathed in, move person into fresh air.
- Consult a physician if necessary.
In case of skin contact
- In case of contact, flush skin with plenty of water while removing contaminated clothing and shoes.
- If skin irritation continues, consult a doctor..
- Wash contaminated clothing before re-use.
In case of eye contact
- Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes.
- Seek medical advice.
In case of ingestion
- Do not induce vomiting without medical advice.
- If victim is conscious:
- Rinse mouth with water.
- Keep at rest.
- Do not give anything to drink.
- Do not leave the victim unattended.
- Vomiting may occur spontaneously
- Risk of product entering the lungs on vomiting after ingestion.
- Lay victim on side.
- Seek medical advice.

Fire-fighting measures

Extinguishing media
Suitable extinguishing media
- Extinguishing media - small fires
- Dry chemical
- Carbon dioxide (CO2)
- Extinguishing media - large fires
- Foam
- Water spray
Unsuitable extinguishing media
- High volume water jet
Special hazards arising from the substance or mixture
Specific hazards during fire fighting
- Under fire conditions:
- Will burn
- Container may rupture on heating.
Hazardous combustion products:
- On combustion or on thermal decomposition (pyrolysis), releases:
- Nitrogen oxides (NOx)
- Carbon oxides
Advice for firefighters
Special protective equipment for fire-fighters
- Firefighters should wear NIOSH/MSHA approved self-contained breathing apparatus and full protective clothing.

Accidental release measures

Personal precautions, protective equipment and emergency procedures
- Wear suitable protective equipment.
- For further information refer to section 8 "Exposure controls / personal protection."
Environmental precautions
- Do not flush into surface water or sanitary sewer system.
- Take all necessary measures to avoid accidental discharge of products into drains and waterways due to the rupture of
containers or transfer systems.
- Spills may be reportable to the National Response Center (800-424-8802) and to state and/or local agencies
Methods and materials for containment and cleaning up
Methods for containment
- Stop the leak. Turn leaking containers leak-side up to prevent the escape of liquid.
- Dam up with sand or inert earth (do not use combustible materials).
Recovery
- Soak up with inert absorbent material.
- Shovel or sweep up.
- Keep in suitable, closed containers for disposal.
- Never return spills in original containers for re-use.
Decontamination / cleaning
- Clean contaminated surface thoroughly.
- Flush with plenty of water.
- Recover the cleaning water for subsequent disposal.
- Decontaminate tools, equipment and personal protective equipment in a segregated area.
Disposal
- Dispose of in accordance with local regulations.

Handling and storage

Precautions for safe handling
- Does not require any specific or particular measures.
- Handle in accordance with good industrial hygiene and safety practice.
- Avoid inhalation of vapor or mist.
- Avoid contact with skin and eyes.
- Freezing will affect the physical condition but will not damage the material. Thaw and mix before using.
- To safely melt this material, use low pressure steam or place in a heated room
- Avoid localized overheating.
- Vent drums while heating
Hygiene measures
- Personal hygiene is an important work practice exposure control measure and the following general measures should be
taken when working with or handling this materials:
- 1) Do not store, use, and/or consume foods, beverages, tobacco products, or cosmetics in areas where this material is
stored.
- 2) Wash hands and face carefully before eating, drinking, using tobacco, applying cosmetics, or using the toilet.
- 3) Wash exposed skin promptly to remove accidental splashes or contact with material.
Conditions for safe storage, including any incompatibilities
Technical measures/Storage conditions
- Take all necessary measures to avoid accidental discharge of products into drains and waterways due to the
rupture of containers or transfer systems.
- Keep container tightly closed in a dry and well-ventilated place.
- Keep away from open flames, hot surfaces and sources of ignition.
- Keep away from incompatible materials to be indicated by the manufacturer
- Keep away from: Strong oxidizing agents
Requirements for storage rooms and vessels
Recommended storage temperature: 41 - 86 °F (5 - 30 °C)

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment
General protective and hygienic measures:
Do not eat, drink, smoke or sniff while working.
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes.
Respiratory protection: No personal respiratory protective equipment normally required.
Protection of hands: Protective gloves.
Eye protection: Tightly sealed goggles (EN 166).
Body protection: Protective work clothing.

Stability and reactivity

Reactivity
- no data available
Chemical stability
- Stable under recommended storage conditions.
Possibility of hazardous reactions
No hazardous reactions known.
Conditions to avoid
- Keep away from heat and sources of ignition.
- Keep away from flames and sparks.
Incompatible materials
- Strong oxidizing agents
Hazardous decomposition products
- On combustion or on thermal decomposition (pyrolysis), releases:
- Nitrogen oxides (NOx)
- Carbon oxides

Disposal considerations

Disposal must be made according to official regulations.
Packaging that may not be cleansed must be disposed of in the same manner as the product.