Registration Dossier

Diss Factsheets

Administrative data

First-aid measures

Immediately remove contaminated clothing.
If inhaled: If difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and seek medical attention.
On skin contact: Wash thoroughly with soap and water.
On contact with eyes: Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist.
On ingestion: Rinse mouth immediately and then drink plenty of water, seek medical attention.
Treatment: Treat according to symptoms (decontamination, vital functions), no known specific antidote.

Fire-fighting measures

Extinguishing media
Suitable extinguishing media: water spray, dry powder, foam
Unsuitable extinguishing media for safety reasons: water jet
Special hazards arising from the substance or mixture harmful vapours
Evolution of fumes/fog. The substances/groups of substances mentioned can be released in case of fire.
Advice for fire-fighters
Special protective equipment: Wear a self-contained breathing apparatus

Accidental release measures

Personal precautions, protective equipment and emergency procedures
Use personal protective clothing. Breathing protection required.
Environmental precautions
Contain contaminated water/firefighting water. Do not discharge into drains/surface waters/groundwater.
Methods and material for containment and cleaning up
For large amounts: Pump off product.
For residues: Pick up with suitable absorbent material. Dispose of absorbed material in accordance with regulations.

Handling and storage

Precautions for safe handling
No special measures necessary provided product is used correctly.
Protection against fire and explosion:
Heated containers should be cooled to prevent polymerization. Take precautionary measures against static discharges.
Conditions for safe storage, including any incompatibilities
Segregate from alkalies and alkalizing substances.
Further information on storage conditions: Protect against heat. Protect from the effects of light. The stabilizer is only effective in the presence of oxygen.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Respiratory protection:
Suitable respiratory protection for higher concentrations or long-term effect: Gas filter for gases/vapours of organic compounds (boiling point >65 °C, e. g. EN 14387 Type A)
Hand protection:
Chemical resistant protective gloves (EN 374). Suitable materials short-term contact and/or splashes (recommended: At least protective index 2,
corresponding > 30 minutes of permeation time according to EN 374) butyl rubber (butyl) - 0.7 mm coating thickness nitrile rubber (NBR) - 0.4 mm coating thickness
Supplementary note: The specifications are based on tests, literature data and information of glove manufacturers or are derived from similar
substances by analogy. Due to many conditions (e.g. temperature) it must be considered, that the practical usage of a chemical-protective glove in
practice may be much shorter than the permeation time determined through testing. Manufacturer's directions for use should be observed
because of great diversity of types.
Eye protection:
Safety glasses with side-shields (frame goggles) (e.g. EN 166)
General safety and hygiene measures
Handle in accordance with good industrial hygiene and safety practice. Wearing of closed work clothing is required additionally to the stated
personal protection equipment.

Stability and reactivity

Reactivity: No hazardous reactions if stored and handled as prescribed/indicated.
Chemical stability: The product is stable if stored and handled as prescribed/indicated.
Possibility of hazardous reactions:
The product can polymerize if the shelf life or storage temperature are greatly exceeded. Heat develops during polymerization. Reacts with peroxide and other radical components.

Disposal considerations

Waste treatment methods: Must be disposed of or incinerated in accordance with local regulations.
Contaminated packaging: Uncontaminated packaging can be re-used. Packs that cannot be cleaned should be disposed of in the same manner as thecontents.