Registration Dossier

Administrative data

First-aid measures

General advice:
Immediately remove contaminated clothing.
If inhaled:
If difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and seek medical
attention.
On skin contact:
Wash thoroughly with soap and water.
On contact with eyes:
Wash affected eyes for at least 15 minutes under running water with eyelids held open.
On ingestion:
Rinse mouth and then drink plenty of water.
Note to physician:
Treatment: Treat according to symptoms (decontamination, vital functions), no known specific
antidote.

Fire-fighting measures

Suitable extinguishing media:
carbon dioxide, dry extinguishing media, water spray, foam
Special protective equipment:
Wear a self-contained breathing apparatus.
Further information:
Dispose of fire debris and contaminated extinguishing water in accordance with official regulations.
Collect contaminated extinguishing water separately, do not allow to reach sewage or effluent
systems.

Accidental release measures

Personal precautions:
Handle in accordance with good industrial hygiene and safety practice.
Environmental precautions:
Do not discharge into drains/surface waters/groundwater.
Methods for cleaning up or taking up:
For large amounts: Pump off product.
For residues: Pick up with suitable absorbent material. Dispose of absorbed material in accordance
with regulations.

Handling and storage

Handling
Ensure thorough ventilation of stores and work areas.
Protection against fire and explosion:
Prevent electrostatic charge - sources of ignition should be kept well clear - fire extinguishers should
be kept handy.
Storage
Further information on storage conditions: Containers should be stored tightly sealed in a dry place.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Components with workplace control parameters
84-69-5: diisobutyl phthalate
Personal protective equipment
Respiratory protection:
Wear respiratory protection if ventilation is inadequate. Gas filter for gases/vapours of organic
compounds (boiling point >65 °C, e. g. EN 14387 Type A)
Hand protection:
Chemical resistant protective gloves (EN 374)
Suitable materials also with prolonged, direct contact (Recommended: Protective index 6,
corresponding > 480 minutes of permeation time according to EN 374):
nitrile rubber (NBR) - 0.4 mm coating thickness
Manufacturer's directions for use should be observed because of great diversity of types.
Supplementary note: The specifications are based on tests, literature data and information of glove
manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g.
temperature) it must be considered, that the practical usage of a chemical-protective glove in practice
may be much shorter than the permeation time determined through testing.
Eye protection:
Safety glasses with side-shields (frame goggles) (e.g. EN 166)
Body protection:
Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting
boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case of
dust).
General safety and hygiene measures:
Handle in accordance with good industrial hygiene and safety practice. Wearing of closed work
clothing is recommended.

Stability and reactivity

Hazardous reactions:
Reacts with strong oxidizing agents.

Disposal considerations

Must be dumped or incinerated in accordance with local regulations.
A waste code in accordance with the European waste catalog (EWC) cannot be specified, due to
dependence on the usage.
Contaminated packaging:
Uncleaned empties should be disposed of in the same manner as the contents.