Registration Dossier

Administrative data

First-aid measures

General advice:
Immediately remove contaminated clothing. If the patient is likely to become unconscious, place and transport in stable sideways position (recovery position). First aid personnel should pay attention to their own safety.

If inhaled:
Keep patient calm, remove to fresh air, seek medical attention. After inhalation of decomposition products: Inhale corticosteroid dose aerosol.

On skin contact:
Immediately wash thoroughly with soap and water, seek medical attention.

On contact with eyes:
Wash affected eyes for at least 15 minutes under running water with eyelids held open.

On ingestion:
Immediately rinse mouth and then drink plenty of water, do not induce vomiting, seek medical attention

Fire-fighting measures

Suitable extinguishing media:
carbon dioxide, dry powder, alcohol-resistant foam, water spray

Unsuitable extinguishing media for safety reasons: water jet

Specific hazards:
carbon monoxide, carbon dioxide, nitrogen oxides, toxic gases/vapours

Special protective equipment:
Wear self-contained breathing apparatus and chemical-protective clothing.

Further information:
Dispose of fire debris and contaminated extinguishing water in accordance with official regulations.
In case of fire and/or explosion do not breathe fumes.

Accidental release measures

Personal precautions:
Do not breathe dust. Avoid dust formation. Ensure adequate ventilation. Avoid inhalation. Avoid contact with the skin, eyes and clothing. Information regarding personal protective measures see, chapter "Exposure controls and personal protection"

Environmental precautions:
Do not discharge into drains/surface waters/groundwater.

Methods for cleaning up or taking up:
For large amounts: Pick up with suitable appliance.
For residues: Sweep/shovel up. Dispose of absorbed material in accordance with regulations.

Handling and storage

Handling
Avoid dust formation. Avoid inhalation of dusts/mists/vapours. Avoid contact with the skin, eyes and clothing. Ensure thorough ventilation of stores and work areas. Refill and handle product only in closed system.

Protection against fire and explosion:
Prevent electrostatic charge - sources of ignition should be kept well clear - fire extinguishers should be kept handy. The product is capable of dust explosion. Avoid dust formation.

Storage
Further information on storage conditions: Keep container tightly closed and dry.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment

Respiratory protection:
Suitable respiratory protection for lower concentrations or short-term effect: Particle filter with medium efficiency for solid and liquid particles
(e.g. EN 143 or 149, Type P2 or FFP2) Suitable respiratory protection for higher concentrations or long-term effect: Self-contained breathing
apparatus.

Hand protection:
Suitable chemical resistant safety gloves (EN 374) also with prolonged, direct contact (Recommended: Protective index 6,
corresponding > 480 minutes of permeation time according to EN 374): E.g. nitrile rubber (0.4 mm), chloroprene rubber (0.5 mm), butyl rubber
(0.7 mm) and other Manufacturer's directions for use should be observed because of great diversity of types.

Eye protection:
Safety glasses with side-shields (frame goggles) (e.g. EN 166)

Body protection:
Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting boots, chemical-protection suit
(according to EN 14605 in case of splashes or EN ISO 13982 in case of dust).

General safety and hygiene measures:
Do not breathe dust. Avoid contact with the skin, eyes and clothing. Remove contaminated clothing immediately and dispose of safely.
Keep separated from food stuffs and feed stocks. No eating, drinking, smoking or tobacco use at the place of work.
At the end of the shift the skin should be cleaned and skin-care agents applied. Employees should shower at the end of the shift.

Stability and reactivity

Thermal decomposition: No decomposition if stored and handled as prescribed/indicated.

Substances to avoid:
acids, alkalies, oxidizing agent, reducing agents

Hazardous reactions:
Dust explosion hazard.

Hazardous decomposition products:
carbon monoxide, carbon dioxide, nitrogen oxides, toxic gases/vapours

Disposal considerations

Observe national and local legal requirements.