Registration Dossier
Registration Dossier
Data platform availability banner - registered substances factsheets
Please be aware that this old REACH registration data factsheet is no longer maintained; it remains frozen as of 19th May 2023.
The new ECHA CHEM database has been released by ECHA, and it now contains all REACH registration data. There are more details on the transition of ECHA's published data to ECHA CHEM here.
Diss Factsheets
Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: - | CAS number: -
- Life Cycle description
- Uses advised against
- Endpoint summary
- Appearance / physical state / colour
- Melting point / freezing point
- Boiling point
- Density
- Particle size distribution (Granulometry)
- Vapour pressure
- Partition coefficient
- Water solubility
- Solubility in organic solvents / fat solubility
- Surface tension
- Flash point
- Auto flammability
- Flammability
- Explosiveness
- Oxidising properties
- Oxidation reduction potential
- Stability in organic solvents and identity of relevant degradation products
- Storage stability and reactivity towards container material
- Stability: thermal, sunlight, metals
- pH
- Dissociation constant
- Viscosity
- Additional physico-chemical information
- Additional physico-chemical properties of nanomaterials
- Nanomaterial agglomeration / aggregation
- Nanomaterial crystalline phase
- Nanomaterial crystallite and grain size
- Nanomaterial aspect ratio / shape
- Nanomaterial specific surface area
- Nanomaterial Zeta potential
- Nanomaterial surface chemistry
- Nanomaterial dustiness
- Nanomaterial porosity
- Nanomaterial pour density
- Nanomaterial photocatalytic activity
- Nanomaterial radical formation potential
- Nanomaterial catalytic activity
- Endpoint summary
- Stability
- Biodegradation
- Bioaccumulation
- Transport and distribution
- Environmental data
- Additional information on environmental fate and behaviour
- Ecotoxicological Summary
- Aquatic toxicity
- Endpoint summary
- Short-term toxicity to fish
- Long-term toxicity to fish
- Short-term toxicity to aquatic invertebrates
- Long-term toxicity to aquatic invertebrates
- Toxicity to aquatic algae and cyanobacteria
- Toxicity to aquatic plants other than algae
- Toxicity to microorganisms
- Endocrine disrupter testing in aquatic vertebrates – in vivo
- Toxicity to other aquatic organisms
- Sediment toxicity
- Terrestrial toxicity
- Biological effects monitoring
- Biotransformation and kinetics
- Additional ecotoxological information
- Toxicological Summary
- Toxicokinetics, metabolism and distribution
- Acute Toxicity
- Irritation / corrosion
- Sensitisation
- Repeated dose toxicity
- Genetic toxicity
- Carcinogenicity
- Toxicity to reproduction
- Specific investigations
- Exposure related observations in humans
- Toxic effects on livestock and pets
- Additional toxicological data
![](https://echa.europa.eu/o/diss-blank-theme/images/factsheets/A-REACH/factsheet/print_ecotoxicological-information.png)
Short-term toxicity to aquatic invertebrates
Administrative data
- Endpoint:
- short-term toxicity to aquatic invertebrates
- Type of information:
- experimental study
- Adequacy of study:
- key study
- Study period:
- 03 December 2014 - 05 December 2014
- Reliability:
- 2 (reliable with restrictions)
- Rationale for reliability incl. deficiencies:
- guideline study with acceptable restrictions
- Remarks:
- Not GLP Compliant
Data source
Reference
- Reference Type:
- study report
- Title:
- Unnamed
- Year:
- 2 015
- Report date:
- 2015
Materials and methods
Test guidelineopen allclose all
- Qualifier:
- according to guideline
- Guideline:
- other: ISO 14669: (Water Quality - Determination of acute lethal toxicity to marine copepods)
- Version / remarks:
- The study procedures described in this report were based on the ISO International Standard 14669:
"Water quality - Determination of acute lethal toxicity to marine copepods (Copepoda, Crustacea);
First edition 1999-04-01. - Deviations:
- no
- Qualifier:
- according to guideline
- Guideline:
- other: OECD 23
- Version / remarks:
- Guidance document on aquatic toxicity testing of difficult substances and mixtures, OECD series on testing and assessment number 23, December 14, 2000.
- GLP compliance:
- no
- Remarks:
- Study not done for EU Reach as an intermediate under SCC but to evaluate the test substance for its ability to generate acute lethal toxic effects on marine copepod Tisbe battagliai.
Test material
- Test material form:
- solid: particulate/powder
Constituent 1
Sampling and analysis
- Analytical monitoring:
- yes
- Remarks:
- The purpose of the analytical phase was to determine the actual concentrations in samples taken from the test solutions used during the ecotoxicity test
- Details on sampling:
- The test samples were stored in the freezer (≤ -15°C). Storage stability of samples under these conditions was demonstrated in project 506881.
On the day of analysis, the test samples were defrosted at room temperature. The samples were diluted in a 3:1 (v:v) ratio with acetonitrile and analysed.
Test solutions
- Vehicle:
- yes
- Details on test solutions:
- 5 μm filtered and UV treated natural marine water of the same origin as the water that was used for culturing the organisms. Water was obtained from Guernsey Sea Farms Ltd., Guernsey, United Kingdom and stored at 4ºC until test initiation.
Test organisms
- Test organisms (species):
- other aquatic crustacea: Tisbe battagliai
Study design
- Test type:
- static
- Water media type:
- saltwater
- Remarks:
- UV treated natural marine water
- Limit test:
- no
- Total exposure duration:
- 48 h
- Post exposure observation period:
- 24 adn 48 hours
Test conditions
- Test temperature:
- 18-22°C, constant within 2°C.
- pH:
- Between 6.0 and 8.5.
- Dissolved oxygen:
- 8.5-9.5 mg O2/l
- Salinity:
- 34%-36%
- Nominal and measured concentrations:
- Solutions containing 1.0, 10 and 100% WSF prepared at a loading rate of 100 mg/l
- Details on test conditions:
- 5.5.2. Test procedure and conditions
Test duration: 48 hours
Test type Static
Test vessels 24-well plastic plates covered with a lid.
Volume of vessel 3 ml
Medium 5 μm filtered and UV treated natural marine water of the same origin as the water that was used for culturing the organisms. Water was obtained from Guernsey Sea Farms Ltd., Guernsey, United Kingdom and stored at 4ºC until test initiation.
Specifications: dissolved oxygen concentration >80% of the air saturation value
pH: 8.0
Salinity: 35‰.
Number of copepodids 20 each in the control and the highest concentration
10 each in the lower concentrations
Loading 5 per vessel containing 2.5 ml of test solution
Light 16 hours photoperiod daily
Temperature 18-22°C, constant within 2°C.
Oxygen concentration ≥ 4 mg/l at the end of the test.
Aeration No aeration of the test solutions.
pH Between 6.0 and 8.5.
Feeding No feeding
Introduction of copepodids Within 0.5 hour after preparation of the test solutions.
5.5.4. Measurements and recordings
Mortality At 24 hours and at 48 hours.
pH and dissolved oxygen At the beginning and at the end of the test, in the control and the highest concentrations (measurements were performed in separate vessels).
Temperature of medium At the beginning of the test, for the control and the highest concentration. In addition, temperature was measured continuously in a temperature control vessel.
5.6. Electronic data capture
Observations/measurements in the study were recorded electronically using the following programme(s):
- REES Centron Environmental Monitoring system version SQL 2.0 (REES Scientific, Trenton, NJ, USA): Temperature.
5.7. Interpretation
5.7.1. Data handling
The 24 and 48h-LCx values could not be determined because test substance appeared to be not toxic.
5.7.2. Acceptability of the test
1. In the control, no copepodids became immobilised.
2. The oxygen concentration at the end of the test was ≥4 mg/l in control and test vessels.
3. The sensitivity of the batch Tisbe battagliai tested was within the range described by the protocol.
5.8. List of deviations
5.8.1. List of protocol deviations
1. Sea water was filtered with 5 instead 1 μm filter.
Evaluation: No other organisms were present tin the medium during the test. Sensitivity of the batch was within the range.
2. In two replicates (1.0% WSF A and 100% WSF B) six instead of 5 tisbes were tested.
Evaluation: This had no effect on the results.
The study integrity was not adversely affected by the deviations. - Reference substance (positive control):
- yes
- Remarks:
- Test medium containing 0.3 mg Zn1/l (positive control).
Results and discussion
Effect concentrationsopen allclose all
- Duration:
- 24 h
- Dose descriptor:
- LC10
- Effect conc.:
- > 0.005 mg/L
- Nominal / measured:
- nominal
- Conc. based on:
- test mat.
- Basis for effect:
- mortality
- Duration:
- 24 h
- Dose descriptor:
- LC50
- Effect conc.:
- > 0.005 mg/L
- Nominal / measured:
- nominal
- Conc. based on:
- test mat.
- Basis for effect:
- mortality
- Duration:
- 48 h
- Dose descriptor:
- LC10
- Effect conc.:
- > 0.005 mg/L
- Nominal / measured:
- nominal
- Conc. based on:
- test mat.
- Basis for effect:
- mortality
- Duration:
- 48 h
- Dose descriptor:
- LC50
- Effect conc.:
- > 0.005 mg/L
- Nominal / measured:
- nominal
- Conc. based on:
- test mat.
- Basis for effect:
- mortality
- Details on results:
- Samples taken from the highest concentration were analysed. The actual concentration was 0.0072 mg/l at the start of the test. The measured concentration decreased to 0.0031 mg/l (43% of initial) at the end of the exposure. The average exposure concentration was calculated to correspond to 0.0047 mg/l. It should be noted that measured values were obtained by either by extrapolation of the calibration curve or calculated using the mean response factor of the lowest calibration solution. Therefore, the average exposure concentration should be considered indicative.
- Results with reference substance (positive control):
- At the end of the test 50% mortality was observed in the reference control. Since the effect in this treatment should be between 20 and 80% it was concluded that the batch tisbe used for this test showed normal sensitivity to Zinc sulphate heptahydrate.
Applicant's summary and conclusion
- Validity criteria fulfilled:
- yes
- Conclusions:
- Under the conditions of the present study with Tisbe battagliai the 48h-LC10 and 48h-LC50 were >0.0047 mg/l, considered the maximum solubility in medium.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.
Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
![ECHA](/o/diss-blank-theme/images/factsheets/A-REACH/factsheet/echa_logo.png)
Nors ECHA internete skelbia daug informacijos jūsų kalba, dalis informacijos šiame puslapyje pateikiama tik anglų kalba. Daugiau apie ECHA daugiakalbystės politiką.
Sveiki atvykę į ECHA svetainę! Ši tinklavietė nepritaikyta naudoti su naršykle Internet Explorer 7 (ir ankstesnėmis jos versijomis). Jums reikalinga naujesnė naršyklės Internet Explorer versija.
Siekdami užtikrinti, kad būtų patogu naudotis mūsų svetaine, jos tinklapiuose naudojame slapukus.
Daugiau informacijos apie tai, kaip naudojame slapukus.