Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: -
CAS number: -
test item was observed to be a light brown viscous gel during
performance of GLP guideline studies.
pour point of the test item was determined to be less than -20 ± 3 °C (<
253± 3 K) (OECD 102 and EU Method A.1).
boiling temperature of the test item was determined to be from
approximately 281 °C (554 K) at 102 kPa. The test item had a broad
boiling range with an extrapolated onset of approximately 400°C (673 K)
(OECD 103 and EU Method A.2).
was determined to be 898 kg/m3 at 20.0 ± 0.5 °C with a relative density
of 0.898 (OECD 109 and EU Method A.3).
accordance with column 2 of REACH Annex VII, Section 7.14, granulometry
does not need to be conducted if the substance is marketed or used in a
non-solid or granular form. The test item is a viscous liquid and, as a
result, determination of particle size distribution is not required.
vapour pressure of the test item was determined to be 2.4 x 10E-02 Pa at
25 °C (298 K).
partition coefficient of the test item has been determined to be greater
than 1.0 x 10E10, with a log10 Pow of > 10.0 (OECD 117 and EU Method
water solubility of the test item was determined to be less than 2.04 x
10E-06 g/L at 20.0 ± 0.5 °C (OECD 105 and EU Method A.6).
of surface tension is not required because water solubility of the test
item has been shown to be less than 2.04 x 10E-06 g/L at 20.0 ± 0.5 °C.
The flash point of the test item was
determined to be 210 ± 2 °C at 100 to 101 kPa (EU Method A.9).
AUTOFLAMMABILITY / SELF-IGNITION
test item was determined to have an auto-ignition temperature of 386 ± 5
°C (EU Method A.15).
to ECHA Guidance on information requirements and chemical safety
assessment chapter R.7a: Endpoint specific guidance (Version 3.0; August
2014), the primary value for ease of ignition in liquids is the flash
point. The flash point of the test item was determined to be 210 ± 2 °C
and used for purposes of CLP classification (non-flammable). Since the
test material does not ignite in contact with air or water, and the
tested sample did not contain impurities with a lower boiling point than
the main component, no further investigation of flammability is required.
on the idealised chemical structure of the test item the result for
explosive properties has been predicted negative.
on the idealised chemical structure of the test item the result for the
oxidizing properties has been predicted negative.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
På den här webbplatsen används kakor. Syftet är att optimera din upplevelse av den.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Do not show this message again