Registration Dossier
Registration Dossier
Diss Factsheets
Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 413-910-1 | CAS number: 1467668-33-2 LUPEROX 610-E-35; LUPEROX 610-E-50; LUPEROX 610-EN-50; LUPEROX 610-M-50; LUPERSOL 610; LUPERSOL 610-M-50
- Life Cycle description
- Uses advised against
- Endpoint summary
- Appearance / physical state / colour
- Melting point / freezing point
- Boiling point
- Density
- Particle size distribution (Granulometry)
- Vapour pressure
- Partition coefficient
- Water solubility
- Solubility in organic solvents / fat solubility
- Surface tension
- Flash point
- Auto flammability
- Flammability
- Explosiveness
- Oxidising properties
- Oxidation reduction potential
- Stability in organic solvents and identity of relevant degradation products
- Storage stability and reactivity towards container material
- Stability: thermal, sunlight, metals
- pH
- Dissociation constant
- Viscosity
- Additional physico-chemical information
- Additional physico-chemical properties of nanomaterials
- Nanomaterial agglomeration / aggregation
- Nanomaterial crystalline phase
- Nanomaterial crystallite and grain size
- Nanomaterial aspect ratio / shape
- Nanomaterial specific surface area
- Nanomaterial Zeta potential
- Nanomaterial surface chemistry
- Nanomaterial dustiness
- Nanomaterial porosity
- Nanomaterial pour density
- Nanomaterial photocatalytic activity
- Nanomaterial radical formation potential
- Nanomaterial catalytic activity
- Endpoint summary
- Stability
- Biodegradation
- Bioaccumulation
- Transport and distribution
- Environmental data
- Additional information on environmental fate and behaviour
- Ecotoxicological Summary
- Aquatic toxicity
- Endpoint summary
- Short-term toxicity to fish
- Long-term toxicity to fish
- Short-term toxicity to aquatic invertebrates
- Long-term toxicity to aquatic invertebrates
- Toxicity to aquatic algae and cyanobacteria
- Toxicity to aquatic plants other than algae
- Toxicity to microorganisms
- Endocrine disrupter testing in aquatic vertebrates – in vivo
- Toxicity to other aquatic organisms
- Sediment toxicity
- Terrestrial toxicity
- Biological effects monitoring
- Biotransformation and kinetics
- Additional ecotoxological information
- Toxicological Summary
- Toxicokinetics, metabolism and distribution
- Acute Toxicity
- Irritation / corrosion
- Sensitisation
- Repeated dose toxicity
- Genetic toxicity
- Carcinogenicity
- Toxicity to reproduction
- Specific investigations
- Exposure related observations in humans
- Toxic effects on livestock and pets
- Additional toxicological data

Toxicity to microorganisms
Administrative data
Link to relevant study record(s)
Description of key information
The effect of 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate on the respiration rate of activated sludge was assessed by the method detailed in Directive (EC) 440/2008, Method C.11, ‘Biodegradation - Activated Sludge Respiration Inhibition Test’. Samples of activated sludge (suspended solids 1.6 g/L), fed with synthetic sewage, were exposed to dilutions of the test substance for three hours. The 3-hour EC50 was calculated to be 756 mg/L (95% confidence limits, 482 to 1230 mg/L). The 3-hour EC20 was calculated to be 102 mg/L (95% confidence limits, 37 to 230 mg/L). The EC80 could not be calculated as this was considered above the highest concentration tested, 1000 mg/L.
Key value for chemical safety assessment
- EC50 for microorganisms:
- 756 mg/L
Additional information
The effect of 3-hydroxy-1,1-dimethylbutyl 2-ethyl-2-methylheptaneperoxoate on the respiration rate of activated sludge was assessed by the method detailed in Directive (EC) 440/2008, Method C.11, ‘Biodegradation - Activated Sludge Respiration Inhibition Test’. Samples of activated sludge (suspended solids 1.6 g/L), fed with synthetic sewage, were exposed to dilutions of the test substance for three hours. Their rates of oxygen consumption were determined using an oxygen electrode and were compared with those of controls that contained activated sludge and synthetic sewage alone and were established at the beginning and end of the test. The study employed nominal concentrations of 10, 30, 100, 300 and (triplicate) 1000 mg/L. The reference inhibitor 3,5-dichlorophenol (3,5-DCP) was employed at 3, 10 and 32 mg/L, as a positive control. The specific respiration rate of the control culture established at the end of the test (Control 2, 37.5 mgO2/g/h) was 89% of the rate established at the start (Control 1, 42.3 mgO2/g/h). The three-hour 50% effect concentration (EC50) for 3,5-DCP was calculated to be 9.2 mg/L (95% confidence limits, 6.2 to 13.7 mg/L). These results show that the sample of activated sludge employed was sensitive to inhibition. Concentration-related inhibition of respiration rates were observed at concentrations between 100 and 1000 mg/L, with the highest concentration (1000 mg/L) showing 51 to 53% inhibition. The three-hour EC50 was calculated to be 756 mg/L (95% confidence limits, 482 to 1230 mg/L). The three-hour EC20 was calculated to be 102 mg/L (95% confidence limits, 37 to 230 mg/L). The EC80 could not be calculated as this was considered above the highest concentration tested, 1000 mg/L.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.
Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
