Registration Dossier

Administrative data

First-aid measures

Eyes: Immediately flush eyes with copious quantities of water for at least 15 minutes holding lids apart to ensure flushing of the entire surface. Seek medical attention if irritation persists.

Skin: Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes. Seek medical attention if irritation persists. Launder contaminated clothing before reuse.

Ingestion: Do not induce vomiting. Never give anything by mouth to an unconscious person. Drink plenty of water. Rinse mouth with water. Seek medical attention. If possible drink milk afterwards.

Inhalation: If breathed in, remove from exposure and move the person to fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. Consult a physician.

Fire-fighting measures

Extinguishing Media: Alcohol-resistant foam, dry chemical, carbon dioxide or water spray.

Special hazards arising from the substance or mixture: Danger of decomposition under influence of heat. Harmful vapours Evolution of fumes/fog.

Fire Fighting Equipment/Instructions: In case of fire, remove the endangered containers and bring to a safe place, if this can be done safely. In case of fire cool containers or take them to a safe place. Contaminated extinguishing water must be treated at a suitable disposal plant in accordance with waste management laws. Take precautionary measures against static discharges. Ensure there are sufficient retaining facilities for water used to extinguish fire. Fire residues should be disposed of in accordance with the regulations. Keep out unprotected persons.

Accidental release measures

Personal precautions, protective equipment and emergency procedures: Put on appropriate personal or protective equipment. Evacuate surrounding areas. Ensure adequate ventilation. No action shall be taken involving any personal risk or without suitable training. Remove all sources of ignition Heat, flames and sparks. Avoid creating dust. Avoid contact with the skin and the eyes. Ensure adequate ventilation.

Containment Procedures: Prevent entry into sewers and waterways. Do not flush into surface water or sanitary sewer system.

Clean-up Procedures: Absorb with inert material (e.g. dry sand or earth), and place in a clearly labelled container for chemical waste. Do not flush with water.

Special Procedures: Personal protective equipment must be worn: Fully protective suit, Respiratory protective device, Helmets, Protective Boots and Gloves. Ventilate area if spilled in a confined space or other poorly ventilated area.

Handling and storage

Handling Procedures: Keep containers closed when not in use. Avoid contact with skin and eyes. In case of insufficient ventilation, wear suitable respiratory equipment. Do not eat, drink or smoke when using this product. Wear personal protective equipment. Launder contaminated clothing before reuse. Empty container contains product residue which may exhibit hazards of product. Dispose of packing or containers in accordance with local, regional, national and international regulations.

Storage Procedures: Keep away from open flames, hot surfaces and sources of ignition. Avoid dust accumulation in enclosed space. Store in a tightly closed container, store in a cool dry well-ventilated area away from incompatible substance. Container should be properly labelled. Do not store near acids.



Transport information

Land transport (ADR/RID)

UN number:
Not Dangerous Goods
Shippingopen allclose all
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

UN number:
Not Dangerous Goods
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

UN number:
Not Dangerous Goods
Remarksopen allclose all

Air transport ICAO/IATA

UN number:
Not Dangerous Goods
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Control of dermal exposure: Handle with rubber gloves, coveralls, apron, boots as necessary to minimize contact. Gloves should be inspected prior to use and have to satisfy the specifications of EU Directive 89/686/EEC and the standard EN 374 derived from it. Use proper glove removal technique to avoid skin contact. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices.

Control of eye/face exposure: Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts.

Control of inhalation exposure: Use respirator with a combination organic vapor and high efficiency filter cartridge if recommended exposure limit is exceeded (e.g. dust mask type N95 (US) or type P1 (EN 143) respirator). Use self-contained breathing apparatus for entry into confined space, for other poorly ventilated areas and for large spill clean-up sites. A respiratory protection program compliant with all applicable regulations must be followed whenever workplace conditions require the use of a respirator.

General: Wash thoroughly after handling this product Eye wash fountain and emergency showers are recommended.

Control of environmental exposure: Do not let product enter into sewers, waterways or ground water system.

Stability and reactivity

Chemical Stability: Stable under normal conditions.

Conditions to Avoid: Avoid all possible sources of ignition (spark or flame). Do not pressurise, cut, weld, braze, solder, drill, grind or expose containers to heat or sources of ignition.

Incompatibility: Oxidizing materials.

Disposal considerations

Waste should only be disposed of via a licensed waste contractor. The European Waste Catalogue (EWC) and European Waste List
(EWL) is a harmonized list of wastes. Waste materials should be classified prior to final disposal with EWC-codes. Wastes and empty containers should be treated based on their classification and properties referring to local and national waste management regulations. Waste management options: Dispose of to non-hazardous or hazardous waste landfill (Council Directive on the landfill of waste 99/31/EU and Council Decision establishing criteria and procedures for the acceptance of waste at landfills 2003/33/EU) or dispose of via hazardous waste incineration.

The generation of waste should be avoided or minimized wherever possible. Dispose of surplus and non-recyclable products via a licensed waste disposal contractor. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste legislation and any local waste management regulations.
Waste codes should be assigned by the user, preferably in discussion with the waste disposal authorities. All wastes containing residues of the substance or its hazardous degradation products shall be classified as hazardous waste.

All wastes containing residues of the substance or its hazardous degradation products should be disposed of as hazardous waste to authorized hazardous waste incineration plants, operated according to Directive 2008/98/EC on waste, Directive 2000/76/EC on the incineration of waste and Best Available Techniques for Waste Incineration as described in the respective BREF of August 2006.

Contaminated packaging: Contaminated packaging should be emptied as far as possible and disposed of as hazardous waste to
incineration plants in accordance with Directive 2000/76/EC. Clean packaging material should be subjected to waste management schemes (recovery, recycling, re-use) according to local waste management regulations.

The substance and its container must be disposed of in a safe way. Care should be taken when handling emptied containers that have not been cleaned or rinsed out. Empty containers or liners may retain some product residues. Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers.