Registration Dossier

Administrative data

First-aid measures

General advice:
Avoid contact with the skin, eyes and clothing. Remove contaminated clothing. If difficulties occur:
Obtain medical attention. Show container, label and/or safety data sheet to physician.
If inhaled:
Keep patient calm, remove to fresh air, seek medical attention.
On skin contact:
After contact with skin, wash immediately with plenty of water and soap. If irritation develops, seek
medical attention.
On contact with eyes:
Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open,
consult an eye specialist.
On ingestion:
Rinse mouth immediately and then drink plenty of water, seek medical attention.
Note to physician:
Treatment: Treat according to symptoms (decontamination, vital functions), no known specific
antidote.

Fire-fighting measures

Suitable extinguishing media:
water spray, water fog, carbon dioxide, foam, dry extinguishing media
Unsuitable extinguishing media for safety reasons:
water jet
Specific hazards:
carbon monoxide, carbon dioxide, hydrogen chloride, hydrogen fluoride, nitrogen oxides
The substances/groups of substances mentioned can be released in case of fire.
Special protective equipment:
Wear self-contained breathing apparatus and chemical-protective clothing.
Further information:
Attention - The product has not yet been fully tested. In case of fire and/or explosion do not breathe
fumes. Keep containers cool by spraying with water if exposed to fire. Collect contaminated
extinguishing water separately, do not allow to reach sewage or effluent systems. Dispose of fire
debris and contaminated extinguishing water in accordance with official regulations.

Accidental release measures

Personal precautions:
Use personal protective clothing. Avoid contact with the skin, eyes and clothing. Remove
contaminated clothes, undergarments and shoes immediately. Information regarding personal
protective measures see, chapter 8.
Environmental precautions:
Do not discharge into the subsoil/soil. Do not discharge into drains/surface waters/groundwater.
Methods for cleaning up or taking up:
For small amounts: Pick up with suitable appliance and dispose of. Pick up with suitable absorbent
material (e.g. sand, sawdust, general-purpose binder, kieselguhr). Contain with dust binding material
and dispose of.
Cleaning operations should be carried out only while wearing breathing apparatus. Dispose of
absorbed material in accordance with regulations. Collect waste in suitable containers, which can be
labeled and sealed. Clean contaminated floors and objects thoroughly with water and detergents,
observing environmental regulations.
Additional information: Attention - The product has not yet been fully tested.

Handling and storage

Handling
Handle in accordance with good industrial hygiene and safety practice. No special measures
necessary if stored and handled correctly.
Storage
Segregate from foods and animal feeds.
Further information on storage conditions: Attention - The product has not yet been fully tested. Protect
against moisture. Keep away from heat. Protect from direct sunlight. Store protected against freezing.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment
Respiratory protection:
Breathing protection if breathable aerosols/dust are formed. Particle filter with medium efficiency for
solid and liquid particles (e.g. EN 143 or 149, Type P2 or FFP2) Respiratory protection in case of
vapour/aerosol release. Gas filter for gases/vapours of organic compounds (boiling point >65 °C, e. g.
EN 14387 Type A)
Hand protection:
Suitable chemical resistant safety gloves (EN 374) also with prolonged, direct contact
(Recommended: Protective index 6, corresponding > 480 minutes of permeation time according to EN
374): E.g. nitrile rubber (0.4 mm), chloroprene rubber (0.5 mm), butyl rubber (0.7 mm) and other
Eye protection:
Safety glasses with side-shields (frame goggles) (e.g. EN 166)
Body protection:
Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting
boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case of
dust).
General safety and hygiene measures:
Handle in accordance with good industrial hygiene and safety practice. Avoid contact with the skin,
eyes and clothing. Wearing of closed work clothing is recommended. Keep away from food, drink and
animal feeding stuffs. No eating, drinking, smoking or tobacco use at the place of work. Hands and/or
face should be washed before breaks and at the end of the shift. Remove contaminated clothing
immediately and dispose of safely.

Stability and reactivity

Conditions to avoid:
Attention - The product has not yet been fully tested. Avoid all sources of ignition: heat, sparks, open
flame. Avoid humidity. Avoid freezing. No data available.
Substances to avoid:
oxidizing agents, bases
Hazardous decomposition products:
carbon monoxide, carbon dioxide, hydrogen chloride, hydrogen fluoride

Disposal considerations

Must be dumped or incinerated in accordance with local regulations.
Contaminated packaging:
Contaminated packaging should be emptied as far as possible and disposed of in the same manner as
the substance/product.