Registration Dossier

Administrative data

First-aid measures

Product-Specific hazards:
Flammable liquid and vapour.
Risk of serious damage to the lungs if swallowed (by subsequent aspiration).
Repeated exposure may cause skin dryness or cracking


General advice :
Take care to self-protect by avoiding becoming contaminated.
Use adequate respiratory protection.
Move contaminated patient(s) out of the dangerous area.
Take off all contaminated clothing and shoes.
Seek medical assistance - show the safety data sheet or label if possible.

Inhalation :
Move to fresh air.
Keep patient warm and at rest.
If breathing is difficult, give oxygen if possible or assisted ventilation, (do not use mouth to mouth).
Get medical attention if breathing difficulties continue.

Skin contact :
Take off all contaminated clothing and shoes.
Immediately flush affected area with plenty of soap and water – continue for at least 15 minutes.
If there are signs of irritation or other symptoms seek medical attention.

Eye contact :
Remove any contact lenses.
Flush eyes with water thoroughly and continuously for at least 15 minutes.
Keep eye wide open while rinsing.
Protect unharmed eye.
If there are signs of irritation or other symptoms seek medical attention.

Ingestion :
Do NOT induce vomiting, if vomiting does occur, have victim lean forward to reduce risk of aspiration. Get medical
attention immediately.
Clean mouth with water and drink afterwards plenty of water.
Do not give milk or alcoholic beverages.
Never give anything by mouth to an unconscious person.


Advice to Physician :
In case of ingestion, Ipecac-induced emesis is not recommended.
Consider use of charcoal as a slurry (240mL water/30 g charcoal). Usual dose: 25 to 100 g in adults.
If determined necessary (and under qualified medical supervision), the stomach should be emptied by gastric lavage with the airway protected by endotracheal intubation.

Fire-fighting measures

Suitable extinguishing media :
LARGE FIRE: Use water spray, water fog or foam. DO NOT use direct water jet.
SMALL FIRE: Dry powder or carbon dioxide (CO2) extinguisher, dry sand or fire fighting foam.

Unsuitable Extinguishing Media :
(Do not use) Direct water jet.
Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam.

Combustion Products :
Carbon monoxide, carbon dioxide and unburned hydrocarbons (smoke).

Specific hazards during fire fighting :
Vapour is denser than air – flashback may be possible over considerable distances.
Containers may explode under fire conditions - use water spray to cool unopened containers.
Do not allow run-off from fire fighting to enter drains or water courses – may cause explosion hazard in drains and may reignite on surface water.

Further information :
Special protective equipment for fire-fighters :
Wear an approved positive pressure self-contained breathing apparatus in addition to standard fire fighting gear.

Accidental release measures

Eliminate all ignition sources (no smoking, flares, sparks or flames in immediate area).

Personal precautions :
Wear personal protective equipment.
Avoid breathing vapours or mist.
Ensure adequate ventilation and absence of sources of ignition.
Beware of accumulation of vapours in low areas or contained areas, where explosive concentrations may occur.

Environmental precautions :
Land spillage :
Prevent further leakage or spillage if safe to do so.
Prevent spillage from entering drains, sewer, basement or confined areas.

Water spillage :
Prevent further leakage or spillage if safe to do so.
If the spillage contaminates rivers, lakes or drains inform respective authorities.

Methods for clean up :
Land spillage:
Contain spillage.
Spillages can be taken up by collection with non-combustible absorbent material, (e.g. sand, earth,
diatomaceous earth, vermiculite) and placed in container for disposal according to local / national
regulations.

Water spillage:
If the Flash Point exceeds the Ambient Temperature by 10 deg C or more, use containment booms and remove from the surface by skimming or with suitable absorbents when conditions permit. If the Flash Point does not exceed the Ambient Air Temperature by at least 10 deg C, use booms as a barrier to protect shorelines and allow material to evaporate. Seek the advice of a specialist before using dispersants.

Further accidental release measures :
Spillages of liquid product will create a fire hazard and form an explosive atmosphere.
Ensure all equipment is non sparking or electrically bonded.
Avoid direct contact with released material.
Stay upwind.
Keep non-involved personnel away from the area of spillage.
Ensure adequate ventilation, especially in confined areas.

Handling and storage

Advice on safe handling :
If repeated and/or prolonged skin exposure to the substance is likely, then wear suitable gloves tested to EN374 and provide employee skin care programmes.
Smoking, eating and drinking should be prohibited.
Avoid all sources of ignition.
Avoid contact with heat, ignition sources and oxidizing agents.
Use only in well ventilated areas.
Containers should be opened only under exhaust ventilation hood.
Use proper bonding and/or grounding procedures.
This material is a static accumulator: Take precautionary measures against static discharges.
Do not allow splash filling of bulk volumes.
Do not use compressed air for filling, discharging or handling.
Do not pressurise, cut, weld, braze, solder, drill, or grind on containers.
The vapour is heavier than air, beware of accumulation in pits and confined spaces.
The product will float on water and can be reignited on surface water.
Ensure that all relevant regulations regarding explosive atmospheres, and handling and storage
facilities of flammable products are followed.
Cleaning, inspection and maintenance of the internal structure of storage tanks must be done
only by properly equipped and qualified personnel as defined by national, local or company regulation.
Dispose of rinse water in accordance with local and national regulations.


Storage :
No smoking.
Store in either mild steel or stainless steel containers or vessels.
Store in a designated cool and well-ventilated place.
Store in the original, tightly closed, container.
Containers which are opened must be carefully resealed and kept upright to prevent leakage.
Keep container tightly closed and properly labelled.
Vapour space above stored liquid may be flammable/explosive unless blanketed with inert gas.
Storage installations should be designed with adequate bunds so as to prevent ground and water pollution in case of leaks or spills.
Fixed storage containers, transfer containers and associated equipment should be earthed and bonded to prevent accumulation of static charge.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Stability and reactivity

Disposal considerations