Registration Dossier

Guidance on Safe Use

Guidance on Safe Use

Currently viewing:

Administrative data

First-aid measures

- Description of first aid measures:
- General information:
Get medical advice/attention if you feel unwell.
Take affected persons out of danger area and lay down.
Immediately remove any clothing soiled by the product.

- After inhalation:
Supply fresh air and be sure to call for a doctor.
In case of unconsciousness place patient stably in side position for transportation.

- After skin contact:
Immediately wash with water and soap and rinse thoroughly.

- After eye contact:
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.

- After swallowing:
Call for a doctor immediately.

- Information for doctor:
- Indication of any immediate medical attention and special treatment needed:
Treat symptomatically.
For specialist advice physicians should contact the Poisons Information Service.

Fire-fighting measures

- Extinguishing media:
- Suitable extinguishing agents:
CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
- For safety reasons unsuitable extinguishing agents:
Water with full jet

- Special hazards arising from the substance or mixture:
During heating or in case of fire poisonous gases are produced.
Sulphur dioxide (SO2)

- Advice for firefighters:
- Protective equipment:
Wear self-contained respiratory protective device.
Do not inhale explosion gases or combustion gases.

Accidental release measures

- Personal precautions, protective equipment and emergency procedures:
Avoid formation of dust.
Wear protective clothing.

- Environmental precautions:
Do not allow to enter sewers/ surface or ground water.

- Methods and material for containment and cleaning up:
Pick up mechanically.
Ensure adequate ventilation.
Disposal must be made according to official regulations.

Handling and storage

- Handling:
- Precautions for safe handling:
Prevent formation of dust.
Ensure good ventilation/exhaustion at the workplace.
- Information about fire - and explosion protection:
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.

- Conditions for safe storage, including any incompatibilities:
- Storage:
- Requirements to be met by storerooms and receptacles:
Store only in the original receptacle.
- Information about storage in one common storage facility:
Do not store together with acids.
- Further information about storage conditions:
Keep container tightly sealed.
Store in dry conditions.

- Additional information about design of technical facilities:
local ventilation

- Exposure controls
- Personal protective equipment:
- General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Do not inhale dust / smoke / mist.

- Respiratory protection:
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

- Protection of hands:
Protective gloves.
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration ofthe penetration times, rates of diffusion and the degradation.
- Material of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer.
- Penetration time of glove material:
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

- Eye protection:
Safety glasses.

- Body protection:
Protective work clothing.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Stability and reactivity

Disposal considerations