Registration Dossier

Administrative data

First-aid measures

Immediately remove contaminated clothing.
If inhaled:
If difficulties occur after vapour/aerosol has been inhaled, remove to fresh air and seek medical
attention.
On skin contact:
Wash thoroughly with soap and water.
On contact with eyes:
Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open,
consult an eye specialist.
On ingestion:
Rinse mouth immediately and then drink plenty of water, seek medical attention.

Symptoms: The most important known symptoms and effects are described in the labelling (see
section 2) and/or in section 11., Further important symptoms and effects are so far not known.

Treatment: Treat according to symptoms (decontamination, vital functions), no known specific
antidote.

Fire-fighting measures

5.1. Extinguishing media
Suitable extinguishing media:
water spray, dry powder, foam
Unsuitable extinguishing media for safety reasons:
water jet
5.2. Special hazards arising from the substance or mixture
harmful vapours
Evolution of fumes/fog. The substances/groups of substances mentioned can be released in case of
fire.
5.3. Advice for fire-fighters
Special protective equipment:
Wear a self-contained breathing apparatus.
Further information:
The degree of risk is governed by the burning substance and the fire conditions. Contaminated
extinguishing water must be disposed of in accordance with official regulations.

Accidental release measures

6.1. Personal precautions, protective equipment and emergency procedures
Use personal protective clothing. Breathing protection required.
6.2. Environmental precautions
Contain contaminated water/firefighting water. Do not discharge into drains/surface
waters/groundwater.
6.3. Methods and material for containment and cleaning up
For large amounts: Pump off product.
For residues: Pick up with suitable absorbent material. Dispose of absorbed material in accordance
with regulations.
6.4. Reference to other sections
Information regarding exposure controls/personal protection and disposal considerations can be
found in section 8 and 13.

Handling and storage

7.1. Precautions for safe handling
No special measures necessary provided product is used correctly.
Protection against fire and explosion:
Take precautionary measures against static discharges.
7.2. Conditions for safe storage, including any incompatibilities
Further information on storage conditions: Keep container tightly closed and dry; store in a cool
place.
7.3. Specific end use(s)
For the relevant identified use(s) listed in Section 1 the advice mentioned in this section 7 is to be
observed.

Transport information

Land transport (ADR/RID)

Shippingopen allclose all
Class:
Not classified as a dangerous good under transport regulations
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

Shippingopen allclose all
Class:
Not classified as a dangerous good under transport regulations
Remarksopen allclose all

Marine transport (IMDG)

Class:
Not classified as a dangerous good under transport regulations
Remarksopen allclose all

Air transport ICAO/IATA

Class:
Not classified as a dangerous good under transport regulations
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Personal protective equipment:
Respiratory protection:
Respiratory protection in case of vapour/aerosol release. Particle filter with medium efficiency for
solid and liquid particles (e.g. EN 143 or 149, Type P2 or FFP2)
Hand protection:
Chemical resistant protective gloves (EN 374)
Suitable materials also with prolonged, direct contact (Recommended: Protective index 6,
corresponding > 480 minutes of permeation time according to EN 374):
nitrile rubber (NBR) - 0.4 mm coating thickness
Supplementary note: The specifications are based on tests, literature data and information of glove
manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g.
temperature) it must be considered, that the practical usage of a chemical-protective glove in
practice may be much shorter than the permeation time determined through testing.
Manufacturer's directions for use should be observed because of great diversity of types.
Eye protection:
Safety glasses with side-shields (frame goggles) (e.g. EN 166)
Body protection:
Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting
boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case
of dust).

General safety and hygiene measures:
Handle in accordance with good industrial hygiene and safety practice. Wearing of closed work
clothing is required additionally to the stated personal protection equipment.

Stability and reactivity

10.1. Reactivity
No hazardous reactions if stored and handled as prescribed/indicated.
10.2. Chemical stability
The product is stable if stored and handled as prescribed/indicated.
10.3. Possibility of hazardous reactions
No hazardous reactions when stored and handled according to instructions.
10.4. Conditions to avoid
See MSDS section 7 - Handling and storage.
10.5. Incompatible materials
Substances to avoid:
strong acids, strong bases, strong reducing agents, strong oxidizing agents
10.6. Hazardous decomposition products
Hazardous decomposition products:
No hazardous decomposition products if stored and handled as prescribed/indicated.

Disposal considerations

Must be disposed of or incinerated in accordance with local regulations.
Contaminated packaging:
Uncontaminated packaging can be re-used.
Packs that cannot be cleaned should be disposed of in the same manner as the contents.