Registration Dossier

Administrative data

explosive properties of explosives
Type of information:
experimental study
Adequacy of study:
key study
Study period:
1 (reliable without restriction)
Rationale for reliability incl. deficiencies:
guideline study

Data source

Reference Type:
study report

Materials and methods

Test guideline
according to
EU Method A.14 (Explosive properties)
GLP compliance:

Test material

Test material form:
solid: crystalline
Specific details on test material used for the study:
Batch number: 2016110462

Results and discussion

Small-scale preliminary testsopen allclose all
thermal sensitivity - Koenen test: diameter of the orifice plate
Remarks on result:
not thermal sensitive if heated under defined confinement
sensitiveness to impact: impact energy (J)
Remarks on result:
not sensitive to impact using an impact energy of 40 J
sensitiveness to friction: friction load (N)
Remarks on result:
not sensitive to friction using a friction load of 360 N

Any other information on results incl. tables




Preliminary Test


For safety reasons, a preliminary test was carried out to establish safe conditions for the performance of the definitive test. A very small sample (about 10 mg) of the test item was subjected to heating without confinement in a Bunsen flame.



Thermal Sensitivity (Effect of a flame)


The test item was filled into the tube in three equal increments of about 9 cm3, each increment being gently consolidated by applying a force of 80 N to the surface. Care was taken to avoid bubbles during filling.

Heating was applied at a fixed rate by four standard gas burners located around the steel tube. The burners were adjusted so that the tip of the internal blue core of the flame almost touches the tube.

Two series of three tests were performed, the first series using a nozzle-plate with a hole 6 mm diameter and the second series using a nozzle-plate with hole of 2 mm diameter.

The three tests with 6 mm diameter orifice plate showed similar behaviour:

After about 74 s, flame more intense;

After about 81 s intense phase characterized by generation of sparks and black smoke. The sample was expelled from the orifice;

End of intense phase after about 257 seconds;

The three tests with 2 mm diameter orifice plate showed a similar behaviour to those with 6 mm diameter orifice plate but a more intense flame.

During the six tests performed on the sample,no explosion occurred during 5 minutes.

The test result is considered negative.



Mechanical Sensitivity (Shock)


The test item in powdered form sieved all that passes through the sieve mesh 0.5mm was placed in a die device, with a cylindrical measure of 40 mm3, which was then centred on a steel anvil. Six tests were performed by dropping a guided 10 kg steel hammer weight from a height of 0.4 m (40 J) onto the die device containing the sample.

No evidence of ignition, explosion or decomposition was obtained during the series of six tests at 40 J performed on the sample.

The test result is considered negative.



Mechanical Sensitivity (Friction)


An aliquot of 10 mm3of test item sieved all that passes through the sieve mesh 0.5mm were placed onto a standard porcelain plate, and brought into contact with a weighted, standard porcelain peg by moving the plate, to and fro, over a distance of 10 mm once in 0.44 seconds.

A series of six tests were performed with a 360 N loading.


No explosion was obtained during the tests (crepitation and/or a report or bursting into flame are equivalent to explosion).

The test result is considered negative

Applicant's summary and conclusion

Interpretation of results:
GHS criteria not met
Not explosive