Registration Dossier

Administrative data

First-aid measures

Description of first aid measures
General information
Remove contaminated soaked clothing immediately and dispose of safely.
In the event of symptoms refer for medical treatment.
Remove the casualty into fresh air and keep him calm.
Skin contact
In case of contact with skin wash off immediately with plenty of water.
Eye contact
In case of contact with eyes rinse thoroughly with plenty of water and seek medical advice.
Do not induce vomiting.
Rinse out mouth and give plenty of water to drink.
Summon a doctor immediately.
Most important symptoms and effects, both acute and delayed
No further relevant information available.
Indication of any immediate medical attention and special treatment needed
No further relevant information available.

Fire-fighting measures

Extinguishing media
Suitable extinguishing media:
dry powder
carbon dioxide
water spray jet
Unsuitable extinguishing media:
No further relevant information available.
Special hazards arising from the substance or mixture
In the event of fire the following can be released:
Nitrogen oxides (NOx)
Advice for firefighters
Special protective equipment:
Use breathing apparatus.
Addition information:
Do not inhale explosion and/or combustion gases.

Accidental release measures

Accidental release measures
Personal precautions, protective equipment and emergency procedures
Avoid contact with eyes and skin.
Environmental precautions
Do not discharge into the drains/surface water/groundwaters.
Methods and material for containment and cleaning up
Take up with absorbent material.
e.g. general-purpose binder
Dispose of absorbed material in accordance with the regulations.

Handling and storage

Precautions for safe handling
No special measures necessary.
Information about fire and explosion protection:
No special measures necessary.
General information:
Do not eat, drink, smoke or sniff while working.
Wash hands before breaks and at the end of work.
Conditions for safe storage, including any incompatibilities
Requirements to be met by storerooms and receptacles:
No special measures necessary.
Information about storage in one common storage facility:
No further relevant information available.
Further information about storage conditions:
Do not keep at temperatures above 30 °C.
Protect from frost.
Specific end use(s)
No further relevant information available.

Transport information

Land transport (ADR/RID)

UN number:
not required
Shippingopen allclose all
not required
Packaging group:
not required
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Appropriate engeneering controls
No further relevant information available.
Personal protective equipment
Eye protection (EN 166)
Hand protection (EN 374)
For permanent contact gloves made of the following materials are suitable (Permeation according to EN 374 Part 3: Level 6):
Nitrile rubber (NBR) gloves
The exact penetration time must be obtained from the manufacturer of the protective gloves and has to be observed.
The determination of penetration times according to EN 374 part III is not performed under practical conditions. Therefore a maximum
wearing time, which corresponds to 50% of the penetration time, is recommended.
Skin protection (EN 465)
protective clothing
Respiratory protection (EN 141/149)
If ventilation insufficient, wear respiratory protection.
General protective measures / hygiene measures
Observe the usual precautions when handling chemicals.

Stability and reactivity

No further relevant information available.
Chemical stability
No decomposition if used and stored according to specifications.
Possibility of hazardous reactions
No further relevant information available.
Conditions to avoid
No special measures necessary.
Incompatible materials
Exothermic reactions with alcohols, amines, aqueous acids and alkalies.
Hazardous decomposition products
None with proper handling and storage.

Disposal considerations

Waste treatment methods
Can be taken to an incineration plant, if relevant regulations in force are being observed and, if necessary, after consulting
the waste disposal agency, respectively the relevant authorities.
Do not allow product to reach the drainage.
Contaminated packaging
Contaminated packaging should be emptied as far as possible and may be reused after appropriate cleansing.