Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 283-392-8
CAS number: 84605-29-8
Description of first aid measures
Wash with plenty of soap and water. If skin irritation occurs, get medical attention. Launder contaminated clothing before reuse.
Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a poison center or doctor.
Remove exposed person to fresh air if adverse effects are observed.
DO NOT INDUCE VOMITING. Get immediate medical attention. Call a poison center or doctor if exposed or you feel unwell.
Advice for first-aid providers
When providing first aid always protect yourself against exposure to chemicals or blood born diseases by wearing gloves, masks and eye protection. After providing first aid wash your exposed skin with soap and water.
Most important symptoms and effects, both acute and delayed
See section “Toxicological Information”.
Indication of any immediate medical attention and special treatment needed
If exposed or concerned: Get medical attention.
Fire Fighting Measures
CO2, dry chemical, or foam. Water can be used to cool and protect exposed material.
Special hazards arising from substance or mixture
Elevated temperatures can lead to the formation of irritating fumes and vapors. See section “Stability and Reactivity” for additional information.
Advice for firefighters
Recommend wearing self-contained breathing apparatus. Water may cause splattering.
Accidental Release Measures
Personal precautions, protective equipment and emergency procedures
Responders should review this MSDS before proceeding with cleanup. Personal protective equipment must be worn. Avoid contact with skin, eyes or clothing.
Ventilate area if spilled in a confined space or other poorly ventilated area.
Take precautions to avoid release to the environment. Prevent from entering into soil, ditches, sewers, waterways and/or groundwater. Check on local, national and international regulatory information to determine any reporting requirements for spills.
Methods and material for containment and cleaning up
Pick up free liquid for recycle and/or disposal. Residual liquid can be absorbed on inert material.
Reference to other sections
See sections “Exposure Controls/Personal Protection” and “Disposal Considerations” for additional information.
Handling and Storage
Precautions for safe handling
Keep containers closed when not in use. Do not discharge into drains or the environment, dispose to an authorized waste collection point. Use appropriate containment to avoid environmental contamination. Avoid breathing vapor. Avoid contact with eyes, skin and clothing. Wash thoroughly after handling. Launder contaminated clothing before reuse. Empty container contains product residue which may exhibit hazards of product. Dispose of packaging or containers in accordance with local, regional, national and international regulations.
Maximum Handling Temperature
70 °C, 158 °F
Maximum Loading Temperature
Conditions for safe storage, including any incompatibilites
Take precautions to avoid release to the environment. Odorous and toxic fumes may form from the decomposition of this product if stored at temperatures in excess of 113 deg F (45 deg C) for extended periods of time or if heat sources in excess of 250 deg F (121 deg C) are used. Store separately from incompatible materials. Store in accordance with local, regional, national and international regulations. See section 10 for incompatible materials.
Maximum Storage Temperature
45 °C, 113 °F
Specific end use(s)
End uses are listed in an attached exposure scenario when one is required.
Exposure Controls/Personal Protection
Other Exposure Limits
Contains mineral oil. Under conditions which may generate mists, observe the OSHA PEL of 5 mg per cubic meter, ACGIH TWA of 5 mg per cubic meter.
Material should be handled in enclosed vessels and equipment, in which case general (mechanical) room ventilation should be sufficient. Local exhaust ventilation should be used at points where dust, mist, vapors or gases can escape into the room air.
Chemical goggles or faceshield.
Gloves, coveralls, apron, boots as necessary to minimize contact. Wear either a chemical protective suit or apron when potential for contact with material exists.
Do not wear rings, watches or similar apparel that could entrap the material and cause a skin reaction. Launder contaminated clothing before reuse.
Use half mask respirator with an organic vapor cartridge if exposure limit is exceeded.
Wash thoroughly after handling this product.
Environmental exposure controls
See section “Accidental Release Measures” for details.
Stability and Reactivity
Carefully review all information provided in the following sections.
Material can become unstable at elevated temperatures and pressures.
187 °C, 368.6 °F
Possibility of hazardous reactions
Will not occur.
Conditions to avoid
Hazardous decomposition products
Smoke, carbon monoxide, carbon dioxide, aldehydes and other products of incomplete combustion. Hydrogen sulfide and alkyl mercaptans and sulfides may also be released. Under combustion conditions, oxides of the following elements will be formed: phosphorus, sulfur, zinc.
Waste treatment methods
All disposal practices must be in accordance with local, regional, national and international regulations. Do not dump into any sewers, on the ground, or into any body of water. Do not dispose in landfill.
Dispose of packaging or containers in accordance with local, regional, national and international regulations.
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
Welcome to the ECHA website. This site is not fully supported in Internet Explorer 7 (and earlier versions). Please upgrade your Internet Explorer to a newer version.
Do not show this message again