Registration Dossier

Administrative data

First-aid measures

Inhalation: Move exposed person to fresh air. Keep person warm and at rest. If not breathing, if breathing is irregular or if respiratory arrest
occurs, provide artificial respiration or oxygen by trained personnel. Get medical attention if symptoms occur. If unconscious, place in recovery
position anget medical attention immediately. Maintain an open airway. Loosen tight clothing such as a collar, tie, belt or waistband.
Ingestion: Wash out mouth with water. Move exposed person to fresh air. Keep person warm and at rest. If material has been swallowed and
the exposed person is conscious, give small quantities of water to drink. Stop if the exposed person feels sick as vomiting may be dangerous. Do not induce vomiting unless directed to do so by medical personnel. If vomiting occurs, the head should be kept low so that vomit does not enter
the lungs. Get medical attention if symptoms occur. Never give anything by mouth to an unconscious person. If unconscious, place in recovery
position and get medical attention immediately. Maintain an open airway. Loosen tight clothing such as a collar, tie, belt or waistband.
Skin contact: Wash contaminated skin with soap and water. Remove contaminated clothing and shoes. Get medical attention if symptoms occur. Washclothing before reuse. Clean shoes thoroughly before reuse.
Eye contact: Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses.
Continue to rinse for at least 10 minutes. Get medical attention if irritation occurs.






Fire-fighting measures

Suitable extinguishing media: In case of fire, use water spray (fog), foam, dry chemical or CO2.
Unsuitable extinguishing media: None known.
Hazards from the substance or mixture: In a fire or if heated, a pressure increase will occur and the container may burst.
Hazardous combustion products: Decomposition products may include the following materials:: carbon oxides
Special precautions for firefighters: Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire. No action shall be taken involving any personal risk or without suitable training.
Special protective equipment for fire-fighters: Fire-fighters should wear appropriate protective equipment and selfcontained breathing apparatus
(SCBA) with a full face-piece operated in positive pressure mode.

Accidental release measures

Personal precautions, protective equipment and emergency procedures: No action shall be taken involving any personal risk or without
suitable training. Keep unnecessary and unprotected personnel from entering. Avoid breathing vapour or mist. Provide adequate
ventilation. Put on appropriate personal protective equipment. Hazard of slipping on spilt product.
Environmental precautions: Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers. Inform the relevant
authorities if the product has caused environmental pollution (sewers, waterways, soil or air).
Small spill: Stop leak if without risk. Move containers from spill area. Dilute with water and mop up if water-soluble or absorb with an inert dry
material and place in an appropriate waste disposal container. Dispose of via a licensed waste disposal contractor.
Large spill: Stop leak if without risk. Move containers from spill area. Prevent entry into sewers, water courses, basements or confined areas.
Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container
for disposal according to local regulations . Dispose of via a licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilt product.


Handling and storage

Precautions for safe handling: Put on appropriate personal protective equipment. Eating, drinking and smoking should be prohibited in areas where this material is handled, stored and processed. Workers should wash hands and face before eating, drinking and smoking. Do not ingest. Avoid contact with eyes, skin and clothing. Avoid breathing vapour or mist. Keep in the original container or an approved alternative made from a compatible material, kept tightly closed when not in use. Empty containers retain product residue and can be hazardous.
Conditions for safe storage, including any incompatibilities: Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials and food and drink. Keep container tightly closed and sealed until ready for use. Containers that have been opened must be carefully resealed and kept upright to prevent leakage. Do not store in unlabelled
containers. Use appropriate containment to avoid environmental contamination.
Recommendations: Not available
Industrial sector specific solutions: Not available
Remarks: Keep away from foodstuffs, acids and alkalis.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (IMDG)

Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Exposure limit values: Not available.
Recommended monitoring procedures: If this product contains ingredients with exposure limits, personal, workplace atmosphere or biological
monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to European Standard EN 689 for methods for the assessment of exposure by inhalation to
chemical agents and national guidance documents for methods for the determination of hazardous substances.
Technical measures: If this product contains ingredients with exposure limits, use process enclosures, local exhaust ventilation or other
engineering controls to keep worker exposure below any recommended or statutory limits.
Respiratory protection: Use a properly fitted, air-purifying or air-fed respirator complying with an approved standard if a risk assessment
indicates this is necessary. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator. Recommended: organic vapour filter (Type A) if product forms vapour/aerosol.
Hand protection: Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical
products if a risk assessment indicates this is necessary. After contamination with product change the gloves immediately and dispose of them
according to relevant national and local regulations Recommended: (< 1 hour) Nitrile rubber - NBR.
Eye protection: Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid
exposure to liquid splashes, mists, gases or dusts. Recommended: Tightly fitting safety goggles.
Skin protection: Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should
be approved by a specialist before handling this product. Recommended: Wear protective clothing.
Hygiene measures: Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated
clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location.
Technical measures: Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of
environmental protection legislation. In some cases, fume scrubbers, filters or engineering modifications to the process equipment will be necessary to reduce emissions to acceptable levels.


Stability and reactivity

Reactivity: No specific test data related to reactivity available for this product or its ingredients
Chemical stability: The product is stable.
Possibility of hazardous reactions: Under normal conditions of storage and use, hazardous reactions will not occur.
Conditions to avoid: Keep away from the following materials: acids and alkalis
Incompatible materials: No specific data.
Hazardous decomposition products: Under normal conditions of storage and use, hazardous decomposition products should not be produced.

Disposal considerations

Methods of disposal: Examine possibilities for re-utilisation. Product residues and uncleaned empty containers should be packaged, sealed,
labelled, and disposed of or recycled according to relevant national and local regulations. Where large quantities are concerned, consult the
supplier. When uncleaned empty containers are passed on, the recipient must be warned of any possible hazard that may be caused
by residues. For disposal within the EC, the appropriate code according to the European Waste List (EWL) should be used. It is among the tasks of
the polluter to assign the waste to waste codes specific to industrial sectors and processes according to the European Waste List (EWL).
Hazardous waste: Within the present knowledge of the supplier, this product is not regarded as hazardous waste, as defined by EU Directive
91/689/EEC.
Methods of disposal: The generation of waste should be avoided or minimised wherever possible. Waste packaging should be recycled.
Incineration or landfill should only be considered when recycling is not feasible.
Special precautions: This material and its container must be disposed of in a safe way. Empty containers or liners may retain some product
residues. Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers.