Registration Dossier

Administrative data

First-aid measures

- 4.1 Description of first aid measures
- General information
Instantly remove any clothing soiled by the product.
In case of irregular breathing or respiratory arrest provide artificial respiration.
- After inhalation
Supply fresh air or oxygen; call for doctor.
In case of unconsciousness bring patient into stable side position for transport.
- After skin contact Instantly wash with water and soap and rinse thoroughly.
- After eye contact Rinse opened eye for several minutes (10 - 15) under running water. Then consult doctor.
- After swallowing Do not induce vomiting; instantly call for medical help.
- 4.2 Most important symptoms and effects, both acute and delayed No further relevant information available.
- 4.3 Indication of any immediate medical attention and special treatment needed
No further relevant information available.

Fire-fighting measures

- 5.1 Extinguishing media
- Suitable extinguishing agents
CO2, extinguishing powder or water jet. Fight larger fires with water jet or alcohol-resistant foam.
- For safety reasons unsuitable extinguishing agents Do not use a heavy water stream.
- 5.2 Special hazards arising from the substance or mixture
Can form explosive gas-air mixtures.
Can be released in case of fire
Nitrogen oxides (NOx)
- 5.3 Advice for firefighters
- Protective equipment:
Wear self-contained breathing apparatus.
Do not inhale explosion gases or combustion gases.
Wear full protective suit.
- Additional information
Dispose of fire debris and contaminated fire fighting water in accordance with official regulations.
Combustible.

Accidental release measures

- 6.1 Personal precautions, protective equipment and emergency procedures
Keep away from ignition sources
Avoid causing dust.
Wear protective clothing (described in section 8).
Avoid contact with substance.
- 6.2 Environmental precautions: Do not allow to enter drainage system, surface or ground water.
- 6.3 Methods and material for containment and cleaning up:
Dispose of contaminated material as waste according to item 13.
Collect mechanically.
Ensure adequate ventilation.

Handling and storage

- 7.1 Precautions for safe handling Prevent formation of dust.
- Information about protection against explosions and fires:
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.
Fumes can combine with air to form an explosive mixture.
- 7.2 Conditions for safe storage, including any incompatibilities
- Storage
- Requirements to be met by storerooms and containers: Store in cool location.
- Information about storage in one common storage facility: Not required.
- Further information about storage conditions:
Keep container tightly closed.
Store in cool, dry conditions in well sealed containers.
Store in a locked cabinet or with access restricted to technical experts or their assistants.
- 7.3 Specific end use(s) No further relevant information available.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all
Remarksopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

- 8.1 Control parameters
- Components with limit values that require monitoring at the workplace:
64-17-5 ethanol
OEL 1900 mg/m3, 1000 ml/m3
- DNELs (Derived no-effect level) No information available
- PNECs (predicted no effect concentration) No information available
- Additional information: The lists that were valid during the compilation were used as basis.
- 8.2 Exposure controls
- Personal protective equipment
- General protective and hygienic measures
The usual precautionary measures should be adhered to general rules for handling chemicals.
Keep away from foodstuffs, beverages and food.
Take off immediately all contaminated clothing
Wash hands during breaks and at the end of the work.
Do not inhale dust
- Breathing equipment: Use breathing protection only if dust is formed.
- Recommended filter device for short term use: Combination filter A-P2
- Protection of hands: Protective gloves (EN 374).
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
- Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer.
- Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
- Eye protection: Tightly sealed safety glasses.
- Body protection: Protective work clothing.

Stability and reactivity

- 10.1 Reactivity No further relevant information available.
- 10.2 Chemical stability
- Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications.
- 10.3 Possibility of hazardous reactions Reacts with strong oxidizing agents
- 10.4 Conditions to avoid No further relevant information available.
- 10.5 Incompatible materials: Strong oxidizing materials
- 10.6 Hazardous decomposition products: No dangerous decomposition products known

Disposal considerations

- 13.1 Waste treatment methods
- Recommendation
After prior treatment product has to be disposed of in an incinerator for hazardous waste under adherence to
the regulations pertaining to the disposal of particularly hazardous waste.
- Uncleaned packagings:
- Recommendation:
Disposal must be made according to official regulations.
Packaging must be disposed of in compliance with country-specific regulations or must be passed to a
packaging return system.
Empty contaminated packagings thoroughly. They can be recycled after thorough and proper cleaning.
Packagings that cannot be cleaned are to be disposed of in the same manner as the product.
15 01 10: packaging containing residues of or contaminated by dangerous substances